User manual WHIRLPOOL WRT108TFYB DIMENSION GUIDE

[. . . ] 3 Location Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electrical Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Water Supply Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Connect the Water Supply. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not depend on the door magnets to hold the doors in place while you are working. 1. Replace the parts for the bottom hinge as shown. Assemble the parts for the center hinge as shown and tighten all screws. Assemble the parts for the top hinge as shown. Align the doors so that the bottom of the freezer door is even with the top of the refrigerator door. Check all holes to make sure that hole plugs and screws are in place. Door Hinge Hole Plug Cabinet Hinge Hole Plug Cabinet 1. From the top of the cabinet, remove the hinge hole plugs, move them to the opposite side, and insert the hole plugs into the holes from where you removed the hinge screws. Remove the screws filling the holes to be used for the Center Hinge and install them on the opposite side. Move the leveler from the bottom of the refrigerator and install it on the opposite side. Move the parts of the top hinge, center hinge and bottom hinge to the opposite side. Remove door hinge hole plug from top of freezer door. Using a level, make sure the refrigerator is still level from side to side. Readjust if necessary. To remove and replace a shelf: 1. Slide the shelf straight out to the stop. Depending on your model, lift back or front of the shelf past the stop. Replace the shelf by sliding the back of the shelf into the track in the wall of the cabinet. Guide the front of the shelf into the shelf track. Be sure to slide the shelf in all the way. Meat Drawer (on some models) To remove and replace the meat drawer: 1. Lift front of meat drawer with one hand while supporting bottom of drawer with other hand. Replace the drawer by sliding it back in fully past the drawer stop. Meat Drawer Cover (on some models) To remove and replace the meat drawer cover: 1. Push the cover back to release the rear clips from the shelf. [. . . ] Push bin or shelf back into the correct position. Make sure the crisper cover is fully pushed in, so that the back rests on the supports. Gaskets are dirty or sticky - Clean gaskets and contact surfaces with mild soap and warm water. New Installation - Allow 24 hours following installation for the refrigerator to cool completely. [. . . ]