User manual WHIRLPOOL WRT111SFAW INSTALLATION GUIDE

[. . . ] If you are unsure of your ability to safely connect the water supply to the unit, consult a licensed plumber for assistance. · This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician in accordance with applicable electrical codes. Safety Alert Definitions Safety items throughout this guide are labeled with a Danger, Warning or Caution based on the risk type: DANGER Danger means that failure to follow this safety statement will result in severe personal injury or death. WARNING Warning means that failure to follow this safety statement could result in serious personal injury, or death. CAUTION Caution means that failure to follow this safety statement may result in minor or moderate personal injury, property or equipment damage. www. U-LineService. com 2 06/2006 CO2175DWR -- Ice Maker/Refrigerator General Precautions Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: 2 Inspect and Plan You have received a carton containing your CO2175DWR Combo Drawer Model Ice Maker/Refrigerator with a package inside containing a Use and Care Guide, a Product Registration Card, water connection parts and Anti-Tip Kit. Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. [. . . ] Go on to 5 Adjust Drawers. 06/2006 9 www. U-LineService. com CO2175DWR -- Ice Maker/Refrigerator Adjusting Drawer Alignment WARNING SHOCK HAZARD -- The unit must be unplugged from the wall outlet during drawer removal, adjustment and re-installation. Minor Adjustment: Note: The mounting holes on the slide are slightly larger than the screws' diameter. Loosen the slide's mounting screws. Push the slide backward. Push Slide Backward Loosen Mounting Screws Drawer Removal 1. Confirm that the unit is unplugged from wall outlet. Unplug the drawer's connection wiring (top drawer only). Pull the drawer completely out of the unit. Figure 15 Severe Adjustment: Note: The slides have extra mounting holes that may be used. Remove the slide's mounting screws. Mark and Drill New Mounting Holes CAUTION Use care when handling the drawer. Drawer edges, drawer rail and the unit's slide may be sharp. 2. Reposition the slide so it is the same distance from the front of the liner as the other slide. Measure to confirm. Push Slide Backward Figure 16 IMPORTANT Drawer adjustments are made by moving the slide that carries the drawer's rail. Measure to confirm. Mark and Drill New Mounting Holes Figure 19 4. Mark new front drilling holes using a different set of mounting holes on the slide. Drill the new holes with a #30 drill bit. Repeat procedure for the other slide. Push Slide Upward or Downward Figure 22 3. Mark new drilling holes using different sets of mounting holes on the slide. Corresponding rear holes will also need to be marked. Drill all the new holes with a #30 drill bit. Remount the slide. Top-to-Bottom (and Left-to-Right) Adjustment Re-installation of Drawer CAUTION Not Aligned Top-to-Bottom Use care when handling the drawer. Drawer edges, drawer rail and the unit's slide may be sharp. Not Aligned Left-to-Right 1. Set the drawer's rails onto the slides. Re-install the rails' mounting screws. [. . . ] Do not discard. A B C Figure 29 2. Insert the screws through the anti-tip bracket (B) and attach the bracket to the unit. Note: The bracket should be flush with the surface it is being attached to. If it is not, loosen the screws and slide the bracket against the mounting surface. [. . . ]