User manual WHIRLPOOL WTW8500BC WARRANTY INFORMATION

[. . . ] See “Washer Care” in your Use and Care Guide for winterizing information. Proper installation is your responsibility. 5" (114 mm) 39" (990 mm) Recessed area or closet installation 3" (76 mm) Minimum diameter for a standpipe drain: 2" (51 mm). Top of standpipe must be at least 39" (990 mm) high; install no higher than 96" (2. [. . . ] Floor drain system requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. To order, please see toll-free phone numbers in your Use and Care Guide. Top of laundry tub must be at least 39" (990 mm) above floor; install no higher than 96" (2. 5" (114 mm) of drain hose should be inside standpipe or below the top of wash tub. 3 ELECTRICAL REQUIREMENTS INSTALLATION INSTRUCTIONS Before you start: remove shipping materials It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. It is recommended that a separate circuit breaker serving only this appliance be provided. N This washer is equipped with a power supply cord having a 3 prong grounding plug. N To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. N If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. N Check with a qualified electrician if you are not sure the washer is properly grounded. If you are only connecting to a cold water faucet, you must use a Y-adapter (not provided). Screw coupling by hand until it is snug. IMPORTANT: To reduce risk of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for future reference. n Periodically inspect and replace hoses if bulges , kinks , cuts , Attach hose to hot water faucet. Screw on coupling by hand until it is seated on washer. use pliers to tighten couplings an additional two-thirds turn. Repeat this step with second hose for cold water faucet. IMPORTANT: Do not overtighten or use tape or sealants on valve when attaching to faucets or washer. Check for leaks Turn on water faucets to check for leaks. A small amount of water may enter washer. [. . . ] If washer is level, skip to step 15, (on models with metal feet) or step 16 (on models with plastic feet). HELPFUL TIP: You may want to prop up front of washer about 4" (102 mm) with a wood block or similar object that will support weight of washer. Tighten leveling feet Jam nut Not Level LEVEL Not Level On models with metal feet, when washer is level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer cabinet. HELPFUL TIP: You may want to prop washer with wooden block. [. . . ]