User manual WHISTLER 1670LD

[. . . ] 1670LD manual 4/11/02 11:48 AM Page 1 OWNER'S MANUAL 1670LD LASER/RADAR DETECTOR THE WHISTLER GROUP CORPORATE HEADQUARTERS 13016 N. Bentonville, AR 72712 TEL (479) 273-6012 FX (479) 273-2927 PRODUCT DEVELOPMENT CENTER 25 Industrial Ave. Chelmsford, MA 01824 TEL (978) 244-1400 FX (978) 244-1491 CUSTOMER RETURN CENTER 1201 N. Rogers, AR 72756 Consumer Relations Tel (800) 531-0004 P/N 1670LDMAN/REV2 © WHISTLER 2002 1670LD manual 4/11/02 11:48 AM Page 3 INTRODUCTION If you have questions concerning the operation of this Whistler product please call consumer relations: Dear Whistler Owner, For many of us, a vehicle is more than just transportation. [. . . ] Display shows: Blinking If the recording time expires for a track, the unit will automatically switch to the next track. Press and release (Quiet/Record) again to stop recording. The unit will automatically stop recording once track 3 is completed. To play a message: · Enter Memo mode and press (Power/Play) to listen to recorded messages. · To play a selected track, press (Volume Up) or (Volume Down) button until selected track appears on the display. Display shows: II = Track 2 Selected · Press the (Power/Play) button. Messages are kept in memory and are not affected by resetting the factory features. See "Reset Features" section of the manual. To delete a message: · Enter Memo mode and press (Volume Up) or (Volume Down) button until selected track appears on the display. · Press the (Quiet/Record) button twice. 16 17 1670LD manual 4/11/02 11:48 AM Page 21 OPERATION To exit Memo mode: · Press (Volume Up) or (Volume Down) buttons simultaneously and release. NOTE: Memo mode automatically exits within 20 seconds if a button is not pressed. Vehicle Battery Saver Mode The Vehicle Battery Saver Mode automatically shuts off your detector within 6 hours if you forget to turn it off. The timer is reset if the detector is turned off, unplugged or any button is pressed before the 6 hours have expired. The detector will alert you with an audible and visual warning before it shuts off. Display shows: Blinking During this warning you can momentarily reset the unit by pressing any button. If the unit has automatically turned itself off, press the (Power/Play) button to turn the unit back on. You can manually engage the Vehicle Battery Saver Mode by pressing and holding the City button until one beep is heard. RADAR ALERTS Speed Radar Audio/Visual Alerts When X, K or Ka is detected the band ID and signal strength is displayed. The audio alert is continuous and has a geiger counter-like pattern. The faster the beep the closer or stronger the radar source. Example: I = weak signal, III = strong signal Pulse Protection® When a pulse type signal (instant on strong signal) is detected an urgent 3 second audio warning is sounded and the display shows: Blinking After 3 seconds standard alert pattern continues. 18 19 1670LD manual 4/11/02 11:48 AM Page 23 SAFETY RADAR ALERTS In communities where transmitters are located, the Safety Warning System alerts you with 60 voice messages. When Safety Radar is detected the audio alert is geiger counter-like. Example: LASER/VG-2 ALERTS Laser Audio/Visual Alerts When a laser signal is detected V/L and signal strength is displayed, the audio alert is continuous for a minimum of 3 seconds. [. . . ] Box please. ) and email address (if applicable). · A detailed description of the problem (e. g. , "Unit per forms self-test but does not respond to radar"). · A copy of your dated store receipt or bill of sale. Be certain your unit is returned with its serial number. [. . . ]