User manual WHISTLER 3400

[. . . ] Bentonville, AR 72712 TEL (479) 273-6012 FX (479) 273-2927 CUSTOMER RETURN CENTER 1201 N. Rogers, AR 72756 Consumer Relations Tel (800) 531-0004 Email: info@whistlergroup. com P/N 202880, © WHISTLER 2003 www. whistlergroup. com OWNER'S MANUAL 3300A/3400 LASER/RADAR DETECTOR www. whistlergroup. com If you have questions concerning the operation of this Whistler product please call: CuSTOmer SeRVICE 1-800-531-0004 Monday - Friday · 8:00 am - 5:00 pm CT or visit our website www. whistlergroup. com Please keep the receipt in a safe place. You may register your product online at www. whistlergroup. com. For warranty verification purposes, a copy of your dated store receipt must still accompany any unit sent in for warranty work. [. . . ] If either Dark or City button is pressed it selects one of two preprogrammed selections, night or truck. Once night or truck is selected you cannot change other features in option select mode. Voice Off Temp On Temp Off Battery Voltage On Battery Voltage Off 13 OPERATION Teach/Tutorial Mode Provides simulated alerts for each type of signal. · Press City and Quiet simultaneously and release. Display reads: Quiet mode can also be accessed while Teach/Tutorial mode is engaged. Voice Module Port Allows you to use an optional Whistler Voice Module, P/N 202971 (See accessory page for ordering, option mode for programming). Any other device may damage the unit and void your warranty. If no signal is detected, two beeps are provided, indicating an "all clear" condition. During VG-2 Alert X, K, and Ka band signals cannot be received. (Reference page 23 for VG-2 information. ) Alert Priority When two or more signals are received at the same time, the alert priority is: 1. Safety Radar Example: If X band is alerting, then suddenly VG-2 is detected, the VG-2 warning will override the X band alert. 17 RESET FEATURES/CARE & MAINTENANCE Reset Features All user features can be reset to factory settings. · · · · · Remove Power from unit. Dim/Dark Mode to full illumination of display. Care And Maintenance Do not spray water, cleaners or polishes directly onto the unit. The spray may penetrate through the openings and damage the unit. Also, do not use any abrasive cleaners on the unit's exterior. 18 COMMUNICATION BREAKDOWN Communication Breakdown If a problem arises between the inside control panel and the outside antennas, the unit will give a unique audio tone. The display reads: R1 ERROR R2 ERROR T Trouble w/ Front Antenna Trouble w/ Rear Antenna ERROR Trouble w/ Temp Probe If a R1 error occurs: · Press P/V to turn unit off. · Check connection in back of control panel (straight ended cable) · Perform "reset features. " · See dealer/installer. If an R2 error occurs: · To temporarily cancel error message, momentarily press either Dark/City/Mute button. Next time unit performs self test it will repeat error message. · To permanently cancel error message, until fixed, press and hold either Dark/City/Mute button. · If no rear antenna is installed, perform "reset features. " · Press P/V to turn off unit. [. . . ] Ship both the console and antenna (CAUTION: DO NOT CUT WIRES when removing the antenna as this will void the warranty. ) in the original carton or in a suitable sturdy equivalent, fully insured, with return receipt requested to: Whistler Repair Dept. 72756 IMPORTANT: Whistler will not assume responsibility for loss or damage incurred in shipping. Therefore, please ship your unit insured with return receipt requested. Include with your unit the following information, clearly printed: · Your name and street address (for shipping via UPS), and a daytime telephone number. [. . . ]