User manual WHISTLER PRO-100W

[. . . ] The Large L bracket fastens to 2 ­ 4 holes on the cover of the antenna. The Large L Bracket may be fastened to the antenna in a variety of positions. Do not drill into the receiver housing! INSTALLATION OF LASER/RADAR ANTENNA The layout of the holes on the large L bracket accommodates multiple antenna mounting positions. This arrangement provides flexibility for fastening the antenna/bracket assembly to your vehicle in a manner that allows the antenna window (ANTENNA) to have a forward looking view of the road ahead. The Small L Brackets (2) may also be fastened to the antenna in different positions as shown below: The small L brackets may be fastened to any of the four holes on the antenna Use one M3 x 20 bolt, washer and nut to fasten each Small L Bracket to the antenna. [. . . ] Mounting the Temperature Probe Find a location that is far enough away from the engine and radiator heat but still in the airflow for the vehicle. Mounting the Probe too close to these heat sources will give a higher than expected result. · Attach the mountable tie wrap (supplied) to the Temperature Probe as shown. · Mark location for Probe, and then drill a hole using a #32 drill bit. Attach Probe with tie wrap in the correct orientation using the 3. 5 x 16 screw. NOTE: Mount the Probe so that there is space between the Probe and the mounting area. Do not mount Probe directly to metal area. Run the cable along the edge of the engine compartment to the firewall. Find a location in the firewall where other wires (or the speedometer cable) enter the passenger compartment and feed the phone jack connection through. Be careful not to interfere with or disconnect other wires, cables, or mechanical systems of your vehicle while routing the antenna cable. If there is no easy way to route the cable through the firewall, you can drill a 15/32" hole. Be careful not to block the rear facing lens when mounted in this manner. Also, clean the appropriate surfaces with isopropyl alcohol before adhering the adhesive side of the fastener to those surfaces. INST ALLA TION OF CONTROL PANEL Installing the Control Panel The control panel may be mounted using the through Dash Bracket or supplied double sided tape. When choosing a mounting location, consider the ease of viewing the display, accessibility of controls (remember Mute Mode may be used frequently), and concealment. The Pro-3600 Control panel can also be mounted sideways and even upside down!Control Panel Mounted with Double Sided Tape. Fasteners can be used to mount the control panel to your vehicle. Before adhering the adhesive side of the fastener to a surface, clean that surface with isopropyl alcohol. Use of double sided tape simplifies control panel installation. Laser antenna mounted to rearview mirror with Hook & Loop Fasteners. Laser Antenna Cable Connection Conceal the cable and plug the phone connector into one of the AUX ports on the iBox. Control Panel Mounted with Through Dash Bracket Installation instructions are provided on the last page of this manual. We recommend using a professional installer if you are not familiar with customized dashboard installations. Control Panel Cable Connection Conceal the cable and plug the phone connector into the DISP port on the iBox. 15 16 INST ALLA TION OF OPTIONALMODULES Voice Module Installation The Voice Module provides audio for all aspects of modes, alerts and GPS features. To install: · Make sure "Voice On" is enabled in Option Mode (default setting). [. . . ] (remember the unit needs to be able to "see" the sky). · GPS module has a magnetic base to make installation easy ­ simply place on a metal area. Must turn GPS on in Option Mode. 17 18 POWER CONNECTION Power Cable Connection The iBox has the power cable attached to it. The ground wire has a "U" type connector which should be fastened to a metal surface that is grounded to the vehicle. [. . . ]