User manual WHISTLER PRO-3600

[. . . ] OWNER'S MANUAL PRO-3600 LASER/RADAR DETECTOR THE WHISTLER GROUP, INC. CORPORATE HEADQUARTERS 3604 NW Frontage Rd. Bentonville, AR 72712 TEL: 479. 273. 6012 FX: 479. 273. 2927 P/N 202902, © The Whistler Group, Inc. 2010 www. whistlergroup. com www. whistlergroup. com INTRODUCTION If you have questions concerning the operation of this Whistler product please call: Dear Whistler Customer, Whistler has utilized its high performance antenna design and incorporated it into a totally new remote installed Laser/Radar detector! [. . . ] · Press City and Quiet simultaneously and release. Display shows: POPTM Mode Alerts Because POPTM Mode radar utilizes the same K or Ka band frequencies, POPTM Mode Alerts will initially be displayed as POP K or POP Ka then switch to band and signal strength. Stay Alert Feature The Stay Alert Feature is designed to test a driver's alertness. To engage (when the unit is not alarming): · Press and hold the City button for approximately 2 seconds. Release the button during or immediately after the alert is given. Display shows: Within 30-60 seconds, two beeps are sounded; to show alertness, the driver must press either the City, Menu, or Quiet buttons within 3-5 seconds. If a button is pressed within 3-5 seconds, the cycle is repeated. Before unit alerts, press PWR to exit this feature. If a button is not pressed within 3-5 seconds, an alarm sounds and the display shows: · Press the DARK button to exit during the Get Rest message. Stay Alert is NOT intended as a substitute for adequate rest. You should NOT operate a vehicle if you are drowsy. During extended periods of vehicle operation, you should take frequent breaks. Improper reliance on the Stay Alert feature may result in vehicle damage, personal injury or death. NEVER OPERATE A VEHICLE IF YOU ARE DROWSY. 20 21 OPERATION VOICE Port This port allows use of the Whistler Voice Module. Any other device may damage the unit and void your warranty. LED Port This port provides additional visual alert as well as simulated security alarm flashing LED when the unit is powered off by the power button. USB Port This port allows product updates to be installed via a USB flash drive (not included) connected to the supplied USB cable. DISP Port This port is for the unit's display module. RADAR1 Port This port is for the Front laser/radar antenna module. RADAR2 Port This port is for the optional Rear laser/radar antenna module. When using the optional rear laser/radar antenna, it is recommended that POP be turned off. AUX 1, AUX 2, AUX 3 Ports These ports allow the use of additional optional modules such as the laser receiver for enhanced coverage. [. . . ] Important: Whistler will not assume responsibility for loss or damage incurred in shipping. Therefore, please ship your unit insured with return receipt requested. Include with your unit the following clearly printed information: · Your name and street address (for shipping via UPS), a daytime telephone number and an email address, if applicable. · A detailed description of the problem (e. g. , "Unit performs self-test but does not respond `to radar"). [. . . ]