User manual WHITE BROWN EX 823

[. . . ] â· Only use attachments supplied with the appliance or recommended by the manufacturer. â· Never use the appliance on or near hot surfaces. Before storing or cleaning the appliance, make sure that it is unplugged from the power supply and that it is completely cooled. â· Do not clean the appliance with abrasive chemicals. [. . . ] Using 7g coffee powder Using 14g coffee powder USING POD: First place the gasket in the bottom of filter , then put the coffee pod. (O) will go off once temperature reaches certain value, now please insert the Valve cover(J) and Filter(k) into the Funnel Bracket (I) in the order indicated (Fig. NOTE: There are three protrusions in the edge of the filter and three gaps in the edge of Funnel bracket, please let protrusion match gap so to have them fitted well, And then fit the Funnel bracket (I) back to the unit and rotate counter-clockwise for steady fitting (Fig. ATTENTION: Once happen unfavorable fitting, repeat the fitting operation once more. Usually, the position under the mark is the place which the funnel bracket is clocked in, the section is the scope which the Funnel bracket fall in when fitting ready. Put the Espresso Cups (100ml) in the middle of the Anti drip tray (E). Once the Coffee Light (O) comes on, it alerts the operator the water temperature has become lower and unsuitable for the brewing any longer, now please press down Brewing Button (P) to stop the brewing. [ATTENTION: Commence to brew coffee only after the Coffee Light (O) is out, and stop the brewing once the Coffee Light (O) is on. STEP 5: Remove the Espresso cup and slowly remove the Funnel bracket (I), which could gradually reduce the pressure of the Filter (K) and avoid spilling coffee everywhere. Now slight water will be coming out of the Steam duct (D). STEP 3: During period of waiting steam generation, prepare the fresh milk. firstly tip the appropriate fresh milk to a container. When the Coffee Light (O) comes out, the machine is ready for frothing milk. STEP 4: Press the Steam Switch (S) ON, wait for several seconds to let the water accumulated in the Steam duct (D) run out for cleaning purpose. Then press down the Steam Switch (T) OFF to terminate the cleaning process. Then move the container to the Steam duct (D) and locate this Steam duct (D) in the middle of this container, and immerse the bottom end of the duct into the fresh milk. [ATTENTION: When milk foam starts to create, operator should lower down somewhat the container to attain the favorable frothing effects and avoid any foam likely from overflowing out of the mouth of the container]. After achieving the expected frothing, press down the Steam Switch (T) OFF to turn off the steam. STEP 7: Rotate the Steam duct (D) inwards, and repeat the above procedure 4 for cleaning purpose. STEP 8: Press Power Button (N) to disconnect the power, empty Anti drip. STEP 1: Repeat the above procedure 1, 2 STEP 2: Put a cup under the steam duct. STEP 3: Press down the steam Switch (S) ON, and press down Brewing Button (P), the pump will work. [. . . ] - Do not use abrasive or chemical products which may damage the surfaces of the appliance. - It is convenient to descale the appliance at least once a year. To do so, use a scaler apt for coffee machines. - After treatment, rinse the conducts several times by operate the appliance just with water. [. . . ]