User manual WHITES ELECTRONICS 5000 D S2

[. . . ] €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ).  The water pressure must be within the values indicated in the Technical data table (see below). [. . . ] Demo* If dON appears on the display, this means that the appliance is in demonstration mode. To deactivate it, press the START/ RESET and ON/OFF buttons simultaneously: dOF should appear on the display. Modifying a wash cycle in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun: press and hold the START/RESET button for 4 seconds. After one long beep and three short beeps, the WASH CYCLE PHASE indicator light will switch off. Select the new cycle and switch the machine back on by pressing the START/RESET button. Half load using the upper rack* If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent. Before selecting the wash cycle press the HALF LOAD button repeatedly: the indicator light will illuminate and the wash cycle will take place only in the upper or the lower rack. Remember to load the upper or lower rack only, and to reduce the amount of detergent accordingly. Adding extra crockery Press the ON/OFF button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the ON/OFF button again: the cycle starts from the point at which it was interrupted.  It is better to use powder detergent in this case. Loading the refined salt In order to obtain the best possible results from a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: The default setting of the water softening system is +. - If using multi-functional tablets (2-in-1 , 3-in-1 , 4-in-1 , etc. ) fill the salt dispenser and set the adjuster to -; if the hardness of the water is greater than 60°fH, set it to +. 20 Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. €¢ Remove the plug from the socket when cleaning the machine and when carrying out maintenance work. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned.  The dishwasher should not be used without filters. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under running water. [. . . ] The crockery has not been dried properly. €¢ The dishes are rattling against each other or against the sprayer arms. €¢ The level of the refined salt is low or the dosage setting is not suited to the hardness of the water (see Rinse aid and salt). €¢ The lid on the salt dispenser is not closed properly. [. . . ]