User manual WHITES ELECTRONICS SM

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. [. . . ] You can arrange the playing order of up to 20 tracks on a CD. ENTER MEMORY for the tracks you want to program in the order you want. You can play the same program again, since the program is saved until you turn off the power or open the CD compartment. ⷠYou can record your own program. After you've created the program, insert a blank tape and press r to start recording. Press the number buttons for the tracks you want to program in the order you want. To cancel Program Play Press MODE until "PGM" disappears from the display. To check the order of tracks before play Press DISPLAY· eNTER MEMORY on the player. Every time you press the button, the track number appears in the programed order. To change the current program Press p once if the CD is stopped and twice if the CD is playing. Then create a new program following the programing procedure. just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them. Note The timer mode is canceled: ­ when you press ( button of the tape player while music plays in the timer mode. ­ when you select "TAPE" using FUNCTION. The t indication lights up and the power goes off. At the preset time, the power will go on, and the music will play. Then the power will go off at the preset time, and the player will enter the standby mode. To check/change when the playback will start Press WAKE UP, then DISPLAY· eNTER MEMORY. Each time you press DISPLAY· To use the player before a timer playback starts Just turn on the player, and then you can use it. If you turn off the player before the preset time, timer playback will start at the preset time. In case of the radio, however, if you listen to the station which is different from the one you tuned in step 1 on page 20, you will hear that station at the preset time. [. . . ] ⷠSince a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or springwound watches away from the player to prevent possible damage from the magnet. on operation · If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate. [. . . ]