User manual X10 EASYTOUCH 35

[. . . ] General Safety Note_______________________________________________________3 Introduction _____________________________________________________________4 Installing the batteries _____________________________________________________5 Description of the ET35 "rubber" keys _______________________________________5 Description of the ET35 "Touchscreen" keys __________________________________6 Programming using 3 Digit Code Tables for the TV, VCR, CD, SAT, CBL, DVD, AUDIO and Marmitek X-10 Home Automation keys _____8 Programming using Brand search method ____________________________________9 Programming using Code search method____________________________________11 Identifying codes found using the search procedures __________________________12 Programming a Macro____________________________________________________13 Channel toggle key ______________________________________________________15 Setting key labels ________________________________________________________17 Code learning___________________________________________________________18 Marmitek X-10 Home Automation _________________________________________20 14. Programming the Home Automation IR/RF mode ________________________21 Extra functions __________________________________________________________23 Controlling your equipment from any place in your home______________________24 Problems and troubleshooting _____________________________________________25 Technical manipulation of the product or any changes to the product are forbidden, due to security and approval issues. Take care of proper starting up the device - consult your user guide. Children should use the device only under adult supervision. [. . . ] One press of the Macro key will execute the whole sequence. A total number of 20 keystrokes can be stored under each of the 9 available Macro keys. Press and hold Setup key until the LED remains on (occurring after approximately 2-3 seconds) and the display shows the Main Setup Screen. Press and release desired Mode key (TV, VCR, SAT, etc. Press and release the digit key the Macro is to be stored under. The first key stored in a Macro must be a Mode key. Press and release desired Mode key (TV, VCR, SAT, etc. Press and release the remote keys (maximum of 20) that are required to be stored in the exact order that they should be transmitted. Use the Touchscreen "SCREEN" key to toggle the screen keys displayed and use the Mode keys for any Mode changes. The Setup key can be used to add delays ­ see separate notes. Note - if you program the maximum of 20 keys, then the Macro will be automatically stored on the 20th keypress. Press and release the Touchscreen "EXIT" key to return to normal operation. "SHIFTED" key commands are not allowed to be included in Macros. 5 second between each IR transmission in the sequence. It may be necessary to have "delays" included in the Macro sequence (e. To enter a delay of 4 seconds, press and release Setup followed by 4. It is not possible to include a Macro within a Macro. Press and hold the Setup key until the LED remains on (occurring after approximately 2-3 seconds) and the display shows Main Setup Screen. Press and release the digit key for the Macro that is to be deleted. the LED will blink off and the Macro is deleted. The Channel-Toggle "P<P" key is a special form of Macro key. The feature allows you to program in two specific channels and switch between them with a single key-press. [. . . ] Press and hold the Setup key for approximately 5 seconds until the LED blinks on then turns off. When pressed, a Channel Up command for the Current Mode code is sent once every 3 seconds. When any other key is pressed the scan will stop. Scanning will automatically time-out after 2 minutes if no key is pressed. [. . . ]