Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual X10 IN12A. We hope that this X10 IN12A user guide will be useful to you.
Lastmanuals help download the user guide X10 IN12A.
Detailed instructions for use are in the User's Guide.
[. . . ] Setting Up the X10 Firecracker Kit
the female DB9 connector on the Interface directly to your PC's serial port. If there is already a device connected to this port, unplug it, connect the Computer Interface, and then plug the other device into the male DB9 connector on the CM17A. [. . . ] If there are any difficulties when attempting to send control commands to the Transceiver, try all of the available COM ports on the computer. If the problems persist, ensure that the Transceiver is operating correctly by following steps 2 and 3 above. For more help, see: http://www. x10. com/support Notes:
Set Up the Transceiver Module Make sure you have connected the Transceiver (model TM751) to a nearby power outlet. The outlet you use should not be too close to the back of your PC, as your PC may create some electrical noise that could reduce the range of the transceiver. Set the House Code (letter dial) on the Transceiver is set to 'A'. Plug a lamp directly into an outlet, and ensure that it is switched on. Next, without switching the lamp off, remove it from the outlet and connect it directly to the Transceiver. Using the PalmPad wireless remote (model HR12A), press the '1 On' button. Next, press the '1 Off' button. If the lamp cannot be controlled in this way, move the wireless transceiver to another outlet until it works. [. . . ] Connect the Firecracker Computer Interface The Computer Interface (model CM17A) uses wireless signals to transmit X10 control commands from the computer to the Transceiver module included in the kit. If you haven't already done so, connect
MODEL NUMBER: IN12A
Copyright 1999 X10 (USA) Inc. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE X10 IN12A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual X10 IN12A will begin.
