Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual X10 IN40A. We hope that this X10 IN40A user guide will be useful to you.
Lastmanuals help download the user guide X10 IN40A.
Detailed instructions for use are in the User's Guide.
[. . . ] This kit is designed to allow you to use your TV and the ScanPad remote to view 3 cameras, and use your PC to view another 3 cameras at home and over the Internet. Follow these instructions to set up the cameras and receivers. See the XRay Vision instructions and help file for more complete information about setting up the software and hardware on your PC. [. . . ] When the camera is set up, turn it off using your ScanPad remote (model CR12A). Repeat these steps for each camera you are setting up. Make sure to choose a different Unit Code for each camera. Set the dials on the power supplies of the next three cameras to the same House Code (letter dial) and set the number dials to 5 through 7. Remove the rubber plug (it looks like a button) on the base of each camera to an unused frequency channel. The positions on the switch are not labeled, but the positions match the 'A' to 'D' settings on the video receiver. Using a paper clip or other small implement, move the switch on the base of each camera to the top-most position, setting 'D'. This sets the cameras to work with the receiver connected to your PC. Set Up Motion Detectors Follow the instructions included with the HawkEye and Eagle Eye motions sensors to configure one sensor for each camera you set up earlier, numbers 1 through 7. Mount each motion sensor in a location near the corresponding camera. Set Up the Transceiver Module Make sure you have connected the Transceiver (model TM751) to a nearby power outlet. The outlet you One of the motion sensors from the first set of cameras (numbers 1-3) that you set up above will also be used to trigger VCR Commander to start recording video. Follow the instructions in the VCR Commander box to program this address into the UX21A/UX23A and learn the commands to record on your VCR. Connect the Firecracker Computer Interface The Computer Interface (model CM17A) uses wireless signals to transmit X10 control commands from the computer to the transceiver module included in the kit. Connect the Interface directly to your PC's serial port. If there is already a device connected to this port, unplug it, connect the Computer Interface, and then plug the other device into the connector on the CM17A. [. . . ] In the "Comment" box you can type a description or name for this camera. Repeat these steps for all the second set of cameras (numbers 5-7) you configured above. You are now ready to control your cameras from XRay Vision. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE X10 IN40A
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual X10 IN40A will begin.
