User manual X10 IN49A SETUP

[. . . ] SETUP INSTRUCTIONS Setting Up XRay Vision with Multiple Cameras Connect the Firecracker Computer Interface The Computer Interface (model CM17A) uses wireless signals to transmit X10 control commands from the computer to the transceiver module included in the kit. Connect the Interface directly to your PC's serial port. If there is already a device connected to this port, unplug it, connect the Computer Interface, and then plug the other device into the connector on the CM17A. [. . . ] Repeat these steps for all the cameras you set up earlier. You are now ready to control your cameras from XRay Vision. Right click in the XRV window and choose "Camera. " You will be able to select from your different cameras, or tell XRV to automatically switch between all of them. Installing XRay Vision Remote Viewer After you have installed the XRay Vision server, you can use the XRay Vision remote viewer look at your images from any PC connected to the Internet. Once again you need to download the software from: Set Up the Transceiver Module Make sure you have connected the Transceiver (model TM751) to a nearby power outlet. The outlet you use should not be too close to the back of your PC, as your PC may create some electrical noise that could reduce the range of the transceiver. Set the House Code (letter dial) on the Transceiver to the letter you will use for your cameras. Connect the Video Receiver to the Video Capture Adapter Plug the yellow video plug on the supplied cable into the Video Out jack on the VR30A. Connect the other end of the cable to the yellow Video In jack on the Video Capture Adapter. Plug the PR30A power supply into any 120V AC outlet. Plug the power output of the PR30A into the DC 12V plug on the VR30A. Make sure the Channel switch on the underside of the VR30A should be set to the same letter as that on the XCam2. http://www. x10. com/xrv This time choose the remote software. Run the file Remote installation application and follow the installation instructions. [. . . ] You are now ready to set up the Video to USB Adapter. Connecting the USB Video Capture Adapter When the installation program instructs you to, plug the Video to USB Converter connector into a USB port on your computer. The computer will recognize that new hardware has been installed and complete the installation. MODEL NUMBER: IN49A © Copyright 2000 X10 Wireless Technology, Inc. [. . . ]