User manual X10 IN55A QUICK SETUP GUIDE

[. . . ] Multi-Camera System Quick Setup Guide (refer to instructions packed with each item for more detailed information) Pip G Look for a box that contains the XCam camera. G Unpack the camera and its power supply. [. . . ] G Set the channel switch on the Video Receiver to 3 or 4. G Turn your TV on and select channel 3 or 4, or select Video if you used the RCA cable to connect the Video Receiver to your TV. The camera's power supply powers up in the on state when you first plug it in, so you will now see a picture on your TV. G Point the "pip" on the Camera's antenna and the "squares" on the Receiver's antenna towards each other for the best reception. G If you experience interference, try setting the Camera and Receiver to a different letter channel (A, B, C, or D) - use the same letter on each (see instructions included with them for more information). G If you have two Receivers you can see the same Camera on two different TVs. Set both Receivers to the same letter channel as the Camera. G Look for a box that contains the Transceiver G Unpack the Transceiver and plug it into any AC outlet. G Press the button on the front of it and check that it "clicks. " G Fully extend the antenna. Follow the instructions packed with it for more info. G Look for a box that includes the remote control, and remove it from the box. The Transceiver will click, and if the camera's power supply (in step above) is set to number 1 it will also turn on and off. [. . . ] This ensures that only one camera is ever transmitting at a time (if two cameras were on at the same time they would scramble the picture on your TV. Wireless Technology, Inc. Congratulations you are finished installing your multi-camera system. For more information or help setting up your system, please visit www. x10. com/support GUIDE IN55A u<0* !)"=dhaeiF<z Copyright 2001, X10 Wireless Technology, Inc. [. . . ]