User manual X10 KR32A

[. . . ] The display then shows ENTER PIN (Personal Identification Number) in the top line. ENTER PIN 12:00 am Arming the system Pressing ARM HOME on the Console arms all Door/Window Sensors instantly. Motion Detectors will not trip the system when it is armed in the ARM HOME mode. Pressing ARM AWAY arms with an exit delay and an entry delay, to give you time to disarm the system after you enter your home. [. . . ] INSTALL ZONE Now simply press any button on the Keyfob remote. The Console acknowledges that it has been registered by beeping and displaying RMOT 1 SET. Repeat this for any other Keyfob Remotes you want to register. The display increments to RMOT 2 SET, etc. Press 1 to go back to the HOME CONTROL screen. Press 2 to stay in the INSTALL menu. **** 12:00 am If the unit is armed it will disarm when the PIN is entered, and return to the time display, with DISARMED in the top line. DISARMED 12:00 am Then after a short delay the display reverts to HOME CONTROL mode. Panic Alarm: Pressing BOTH Panic buttons on the Keyfob remote at the same time trips the alarm, even if the system was not armed. Battery Replacement Providing the batteries have not already failed, they can be replaced with fresh batteries without the need to reinstall the remote. After removing the old batteries fresh batteries must be fitted within 30 seconds to ensure that the security code is retained. Gently pry the 2 halves of the Keyfob remotes case apart and install two CR2016 lithium batteries battery in the compartment (+ facing up). Press the 2 halves of the cabinet back together. Once the batteries have been replaced, confirm that the remote is still registered in the Console by arming the system. If it does not arm, the code has been lost and you will need to proceed as described below. If the batteries have failed completely, the security code will have been lost. You will need to reinstall the Keyfob remote following the directions in this instruction sheet. Security Keyfob Remote Model KR32A FCC Statement THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. NOTE: NO CHANGES OR MODIFICATIONS MAY BE MADE TO THE UNITS. [. . . ] The Owner's Manual for the Security System describes the full installation process for the Security System, and should be referred to as a supplement to this instruction sheet. *Note: Door/Window Sensors and Motion Detectors may be added in any combination up to a total of 30, e. g. 15 Door/Window Sensors and 15 Motion Detectors, or any combination up to a total of 30 . [. . . ]