User manual X10 MS15A

[. . . ] It can also turn lights on at dusk and off at dawn, but this feature is disabled by default (see other side of sheet to enable). Installation: Remove the screw from the front of the unit (MS16A only). Remove the battery cover and install two AAA alkaline batteries. The unit defaults to Housecode A and Unit Code 1, and it defaults to see motion at all times - day and night, so plug in an X10 RF Transceiver (model RR501 or TM751, each sold separately) and set it to Housecode A. [. . . ] Hold the button pressed for 3 seconds on the last press. The red light then reports the setting with the appropriate number of blinks as above. Note: for settings of 2 blinks or higher, the dial on the top of the unit is disabled. To change the Unit Code that the ActiveEYE transmits: Press and hold the Unit/Off button (under the battery compartment lid) the red light flashes first and then blinks the current setting. Release and immediately press the button the desired number of times for the Unit Code you want to set. Hold the button for 3 seconds on the last press. The red light blinks back the number of times for the code you set. To change the House Code that the ActiveEYE transmits: Press and hold the House/On button (under the battery compartment lid) the red light flashes first and then blinks the current setting (once for A, twice for B, etc. ). Release and immediately press the button the desired number of times for the House Code you want to set (once for A, twice for B, etc. ). Hold the button for 3 seconds on the last press. The red light blinks back the number of times for the code you set. MS15A/MS16A-4/02. 1 of 2 To turn additional lights on when it gets dark. The ActiveEYE can send signals when it detects dusk and dawn so it can turn a light on when it gets dark and turn it off when it gets light (in addition to turning lights on when it detects motion). To have it turn a light on at dusk and off at dawn plug the light into an X10 Module and set it to the same Housecode as the ActiveEYE and to a Unit Code that is one number higher than the Unit Code of the module or camera that turns on when motion is detected. if the ActiveEYE turns on A1 when it detects motion, it will turn on A2 when it gets dark and turn it off when it gets light. You then need to enable this feature, see below for details. If you use this feature, care should be taken to place the Motion Sensor where it sees plenty of sunlight during the day (such as near a window). If you place it in a dark corner it might not be able to tell the difference between day time and night time. Care should also be taken not to place the Motion Sensor near the light it is controlling, otherwise when the light turns on it might "fool" the Motion Sensor into thinking it's daytime, so it will turn the light off again!Note: If you use the Motion Sensor to control X10 wireless cameras, care should be take not to set any cameras to the code that the Motion Sensor sends at dusk and dawn (Unit Code +1). Otherwise your cameras will be turned off at dawn. To set whether you want the ActiveEYE to transmit EVERY time it sees motion or only at night; and to enable or disable the "Unit Code +1" function to turn lights on/off at dusk/dawn: Press the Unit/Off button once. [. . . ] (X10) warrants X10 products to be free from defective material and workmanship for a period of one (1) year from the original date of purchase at retail. X10 agrees to repair or replace, at it's sole discretion, a defective X10 product if returned to X10 within the warranty period and with proof of purchase. Please visit www. x10. com/warranty to complete your on-line warranty registration. Thank you. FCC CAUTION: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. [. . . ]