User manual X10 RT504

[. . . ] The Console acknowledges that it has been registered by beeping and displaying RMOT 1 SET. Repeat this for any other Keyfob Remotes you want to register. The display increments to RMOT 2 SET, etc. , as you register more remotes. Installing the Motion Detectors · Set the slide switch (on the back) to position 1 for instant triggering for maximum sensitivity, or position 2 to trigger only after two movements have been sensed. · Attach the Motion Detector to a wall at a height of 5 to 6 ft. , using the mounting bracket and screws provided. [. . . ] · Point the Motion Detector so that it looks slightly downwards. If you are registering Door/Window Sensors: 90° Some of the accessories available are shown below. The models you purchase may vary from those shown below. See your owner's manual or visit www. x10. com for more information. Move the magnet away from the Door/Window Sensor. The Console acknowledges that it has been registered with a chime and by displaying ZONE 1 SET. 5-6ft ON MOTI CTOR DETE Initializing Motion Detectors Remove the cover on the front of the Motion Detector and install 2 AA alkaline batteries in the battery compartment. Replace the cover (some types of unit have a tamper switch). Press and hold the TEST button on the back of the Motion Detector for 3-4 seconds and then release it. This initializes the Motion Detector and picks a random code that is used when it is registered with the Console. Place the unit face down, so that it won't see any motion during the registering process. Repeat this for any other Door/Window Sensors you want to register. The display increments to ZONE 2 SET, etc. , as you register more Door Window Sensors. 30-40ft If you are registering the Motion Detector: Press the TEST button on the back of the Motion Detector (or turn the unit over so that it sees motion). Install 4 AA alkaline batteries (not supplied) in the Console's battery compartment. Registering the devices All features (except Home Control) require access to the Menu mode. To do this, press either of the Menu Start up or down buttons. The display then shows ENTER PIN (Personal Identification Number) in the top line. The default PIN is 0000, see your owner's manual if you want to change this, but for now press 0000 on the keypad. This clears the top line and shows * for each number entered. After pressing a Menu Start up or down button and entering the PIN, the First Level Menu (INSTALL) is displayed. To select a menu option, press the up or down Menu Start button repeatedly to step through the menu items 1 through 9. Once you arrive at the menu item you desire, press OK to select it. To leave the First Level Menu, repeatedly press the Clear button. Installing the Door/Window Sensors · Set the DELAY slide switch (inside the Sensor) to MIN (for windows) to always trigger the alarm instantly, or to MAX (for doors) to trigger the alarm after a preset entry delay when the system is armed in the AWAY mode. [. . . ] To leave the First Level Menu, repeatedly press the Clear button. Installing the Door/Window Sensors · Set the DELAY slide switch (inside the Sensor) to MIN (for windows) to always trigger the alarm instantly, or to MAX (for doors) to trigger the alarm after a preset entry delay when the system is armed in the AWAY mode. · Attach the Door/Window Sensor to the wall using the mounting screws provided (replace the cover). · Fit the Door/Window Sensor as high as possible at the top of the door/window. · Make sure the arrows on the magnet and the Door/Window Sensor are facing each other and that they separate cleanly when the door or window is opened. [. . . ]