User manual X10 VR30A

[. . . ] The Video Receiver converts the signals back to A/V signals which are fed through a cable to your TV's COAX or A/V input jacks. By purchasing additional VR30As you can view your DBS receiver VCR, Cable Box, etc. , on more than one TV. CONTROLS AND CONNECTIONS 2. 4 GHz Video Antenna TV Output Connector ON-OFF Switch (on side) Power Supply Jack A/V Jacks FCC CAUTION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturers instructions, it may cause interference to radio and television reception. [. . . ] If there are no LINE IN jacks, you will need to use a TV antenna splitter as described earlier. IF YOU WANT TO USE YOUR VIDEO SENDER TO TRANSMIT FROM YOUR STEREO SYSTEM ONLY Just hook up the Video Sender using only the red and white jacks for the right and left channels of the audio signal. Leave the yellow (video) jack and COAX cable unconnected. IF YOUR TV DOES NOT HAVE A/V CONNECTORS You can use the supplied coaxial cable to connect the TV OUT socket on the Audio/Video Receiver to the Antenna input on your TV. If you already have an antenna connected to your TV, you will need to use a TV antenna splitter. Set your TV and the TV Channel switch on the Audio/Video Receiver (on bottom) to the same channel (3 or 4). 4 5 TROUBLESHOOTING If you do not see a picture on your TV: Check that the Sender and the Receiver are on the same letter channel (A, B, C, or D). The channel switches are on the bottom of the units. There is a power light on the front of each unit. Check that the power switch on the side of each unit is ON. Verify that your connections to the TV are correct. If you are using the RCA jacks, make sure you are using the appropriate input mode for your TV, try pressing the A-B button or Video button on your TV's remote control to change the input mode (consult your TV's owner's manual, if necessary). If you are using the Coax cable, verify that the Receiver and the TV are on the same channel (3 or 4). If you connected the Receiver to a VCR and then connected the VCR to your TV, you might need to turn the VCR OFF to see the picture on your TV. Or you might need to turn the VCR on, AND set it to record the picture from the Video Sender, in order to see the picture on your TV. Or you might need to press the A-B button on your VCR's remote control. Consult your VCR's owner's manual from more information. If you get a picture but the quality is poor: Try different positions for the antennas on the Sender and Receiver. The system usually works best with the flat side of the antennas facing each other (see diagram below). Sometimes, however, reflections and other effects in the home may affect the signal so that some adjustment of either the Sender or Receiver antenna may be necessary to get the best the signal. Point antennas at each other Take a look at what the video signal is passing through or near to get to the Receiver. Metal objects and electromagnetic fields can distort the signal. Try to keep the Receiver as far away from other devices as the cables allow. In most cases, relocating the Sender or Receiver a few feet is enough to avoid the source of interference. [. . . ] UNITS TO BE RETURNED SHOULD BE PACKED CAREFULLY. THIS WARRANTY DOES NOT EXTEND TO ANY X10 PRODUCTS WHICH HAVE BEEN SUBJECT TO MISUSE, NEGLECT, ACCIDENT, INCORRECT WIRING OR TO USE IN VIOLATION OF OPERATING INSTRUCTIONS FURNISHED BY US, NOR EXTEND TO ANY UNITS ALTERED OR REPAIRED FOR WARRANTY DEFECT BY ANYONE OTHER THAN X10. THIS WARRANTY DOES NOT COVER ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR IMPLIED AND NO REPRESENTATIVE OR PERSON IS AUTHORIZED TO ASSUME FOR US ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF OUR PRODUCTS. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, AND/OR THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO THE ORIGINAL CUSTOMER. [. . . ]