User manual XACT UNIVERSAL ANTENNA INSTALLATION GUIDE

[. . . ] Your new Satellite Radio Antenna is designed to optimally receive both signals from Sirius satellites and terrestrial (ground) transmitters. This antenna has been approved by Sirius Satellite Radio, Inc. to receive signals under a variety of conditions within Sirius North American coverage area. [. . . ] Use a plastic knife or other blunt object to lift the rubber molding and tuck the cable underneath. Route cable down the window to the lowest point and into the trunk area, using existing cable channel or wiring conduit, and through the interior trim to receiver location. Once the cable is routed through to the trunk and you are happy with the location, remove the protective backing from one side of the adhesive strip and press it firmly along the bottom of the tail piece, over the cable guide. Next, remove the other protective backing on the adhesive and firmly place this onto your vehicle's surface. Make sure you are satisfied with the location and press firmly down on the tail for at least 30 seconds. If you intend to transfer the antenna from your car to your home, we do not recommend using the adhesive strip. 3 INSTALLATION PRECAUTIONS It is recommended that the antenna be installed at or above room temperature, as lower temperatures may cause the antennas tail to not adhere properly. Maximum adhesion usually occurs within 72 hours at room temperature. Car washes as well as other contact with the antenna and tail should be avoided at this time. Warmer temperatures will allow for easier antenna installation over-all, including easier routing of the antenna cable through the rubber molding around windows and other objects on your vehicle. VEHICLE ANTENNA MOUNTING 3. Without Tail Installation: Follow instructions above, but locate antenna at edge of rear window. 4 HOME ANTENNA MOUNTING Your new Satellite Radio Antenna has a strong magnetic mounting to hold the antenna in place and to allow for easy installation in your home or vehicle. Antenna Installation: Place the magnetic Satellite Radio Antenna on top of the Antenna Mounting Home Bracket (see Figure 3). Antenna Placement: Position the Antenna Mounting Home Bracket in a suitable location preferably close to a window. 5 Roof Rear Window Rear Window Roof Figure 1 Figure 2 Figure 1 and 2 are examples of proper antenna location (with and without tail). Note: If the vehicle has a roof rack or skid ribs, it is necessary to mount the antenna off-center, away from barriers that could interfere with reception. 4. Refer to the Sirius Magnetic Mount Satellite Radio Antenna Installation Manual provided for details related to the antenna Installation for your specific vehicle type. Additional instruction and trouble shooting recommendations can be found in the XTR7CK Satellite Radio Receiver User Guide. Warning: Make sure not to cut, damage or puncture the external jacket of the cable during installation procedure. Damage to the cable can cause signal to be degraded or unavailable and can also cause water to wick up into the antenna causing the antenna to fail. Figure 3 3. Antenna Aiming: When using the XACT Sirius XTR Receiver indoors, it is important to locate the antenna in an acceptable location. Refer to installation guides (XTR7CK Satellite Radio Receiver User Guide and XS072 Home Docking Station Installation Guide) for more information. [. . . ] Area 4 : Place the antenna at a WEST - or NORTH - facing window. Area 5 : Place the antenna at a NORTH - facing window. Area 6 : Place the antenna at a NORTH - or EAST - facing window. [. . . ]