User manual XEROX PHASER 3100MFP

[. . . ] The Sagem Fax ATA 101S is a voice over IP gateway allowing you to connect analog terminals (fax machine, telephone, etc. ) to a voice over IP infrastructure (IP operator , IPPBX or VoIP gateway). Through the Sagem Fax ATA 101S, you can continue to use your analog telecommunications peripherals via your voice over IP telephone architecture. The bandwidth to be reserved depends on the codec you use: · 1 power supply unit CAUTION! [. . . ] 729 Audio coding standard, more specifically used in human voice coding telephony. Using this standard is equivalent to coding the voice signal at 8 kbps. It is mostly used by voice over IP operators. It is responsible for authenticating and locating multiple participants, and also for negotiating the types of media that can be used by participants. 38 Protocol used to convert FAX data into IP packets. This protocol is principally used to remotely load firmware and setup files in computer hardware. Read these safety notes carefully before using this product to make sure you operate the equipment safely. Warning: This warning alerts users to areas of the product where there is the possibility of personal injury. Your Sagem Communications product and recommended supplies have been designed and tested to meet strict safety requirements. These include safety agency approval, and compliance to established environmental standards. Please read the following instructions carefully before operating the product and refer to them as needed to ensure the continued safe operation of your product. The safety and environment testing and performance of this product have been verified using Sagem Communications materials only. Warning: Any unauthorized alteration, which may include the addition of new functions or connection of external devices, may impact the product warranty. Please contact your authorized Service Provider for more information. Warning Markings: All warning instructions marked on or supplied with the product should be followed. Do not remove the type plate from your device; this would voice the warranty. Protect the device against direct sunlight, heat, large temperature fluctuations and moisture. do not place the device in the vicinity of heaters or air conditioners. In the event that the device becomes too hot, or if you see smoke coming from the device, you must immediately pull the power cable out of the power socket. have your device examined by trained professionals at a technical service location. To prevent the spread of fire, open flames should be kept away from the device. This product shall be operated from the type of electrical supply indicated on the product's data plate label. [. . . ] Neither Sagem Communications nor its affiliates shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this product, or failure to strictly comply with Sagem Communications operating and maintenance instructions. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of Sagem Communications. The information contained herein is designed only for use with this product. Sagem Communications is not responsible, if this information is applied to other devices. [. . . ]