User manual XEROX PHASER 8860

[. . . ] Contents of this publication may not be reproduced in any form without permission of Xerox Corporation. Copyright protection claimed includes all forms of matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted, including without limitation, material generated from the software programs which are displayed on the screen such as styles, templates, icons, screen displays, looks, etc. XEROX®, CentreDirect®, CentreWare®, FinePointTM, Phaser®, PhaserSMART®, PrintingScout®, and Walk-Up® are trademarks of Xerox Corporation in the United States and/or other countries. Adobe Reader®, Adobe Type Manager®, ATMTM, Flash®, Macromedia®, Photoshop®, and PostScript® are trademarks of Adobe Systems Incorporated in the United States and/or other countries. [. . . ] Adjust the paper guides to fit the labels loaded in the tray. On the control panel, press the OK button if the correct paper size and Labels are displayed as the current setup, or select the label size and type: a. Select the appropriate paper size, and then press the OK button. In the printer driver, select either Labels as the paper type or Tray 1 as the paper source. Insert a maximum of 400 sheets of labels into the tray with the side to be printed faceup and the top of the page toward the front of the tray. Adjust the paper guides to fit the labels (if necessary). Length guide: Press the sides, then slide the guide until the arrow on the guide points to the appropriate paper size imprinted on the bottom of the tray. When properly positioned, the guide clicks into place. Width guides: Slide the width guides until the arrows on the guides point to the appropriate paper size labeled on the bottom of the tray. When properly positioned, the guides click into place. Note: When the paper guides are adjusted correctly, there may be a small space between the labels and the guides. Insert the tray into the tray slot, and then push it completely into the printer. Select either Tray 2 Paper Type, Tray 3 Paper Type, or Tray 4 Paper Type, and then press the OK button. In the printer driver, select either Labels as the paper type or the appropriate tray as the paper source. Glossy paper can be printed, one- or 2-sided, from any tray. To order paper, transparencies, or other specialty media, contact your local reseller or go to the Xerox Supplies website for your printer: Do not open sealed packages of glossy paper until you are ready to load them into the printer. Leave glossy paper in the original wrapper, and leave the packages in the shipping carton until ready to use. Remove all other paper from the tray before loading glossy paper. Load only the amount of glossy paper you are planning to use. Do not leave glossy paper in the tray when you are finished printing. Long periods of storage in extreme conditions can cause glossy paper to curl and jam the printer. Pull down and out on the handle to open Tray 1. [. . . ] Coverage may vary outside these areas; please contact your local representative for details. Follow these guidelines to avoid injuring yourself or damaging the printer: Always allow the printer to cool before it is moved to avoid ink spills that can damage the printer. warning: Parts of the printer may be hot. To avoid personal injury or damage to the printer, allow 30 minutes for it to cool down before moving or packing the printer. [. . . ]