User manual XEROX WORKCENTRE 5675

[. . . ] Press the <Machine Status> button on the machine. On the [Machine Information] screen, select [Print Reports]. Press the <Start> button on the machine. 1 Quick Network Setup (DHCP) 4. [. . . ] Read the Configuration Report to confirm that an IP address has been allocated and that it is a valid IP address on your network. Note If the IP address starts with 169. xxx. xxx. xxx, then the DHCP server has not properly allocated an address or DHCP is not enabled on your network. From a workstation, open a web browser (such as Internet Explorer), and then enter the machine's IP address. If connected properly, you should see the CentreWare Internet Services web page for your machine. Note CentreWare Internet Services is a powerful tool for configuring the machine remotely. The default user name is "11111" and the passcode is "x-admin". The user name and passcode are case sensitive and should be changed after install. Load the print drivers on the computers that will be accessing the machine. 2 Quick Network Setup (Static IP) Quick Network Setup (Static IP) Prerequisites for Manual Setup of Network Using Static IP Address Note On startup, the WorkCentre multifunction machine defaults to DHCP to obtain its network configurations, so DHCP must be turned off by manually entering a static IP address. Before installing, record the following information for use during setup: TCP/IP Address: Gateway Address: Subnet Mask (for IPv4) / Prefix (for IPv6): DNS Server Address: Note To obtain this information, contact your System Administrator. Procedure for Manual Setup of Network Using Static IP Address 1. Select [IPv4 - Gateway Address], and then [Change Settings]. Using the same method as in step d. , enter the Gateway Address. Note If you do not wish to set the gateway address, leave this field blank. Select [IPv4 - IP Filter], and then [Change Settings]. Select [Enabled] to filter access to the machine. Note If you do not wish to use the IP filter feature, select [Disabled]. When you have finished establishing TCP/IP, select [Close] on the [Protocol Settings] screen. When IPv6 Mode or Dual Stack is selected in step 7. a. Set [IPv6 Address Manual Configuration] to [Enabled]. Select [Manually Configured IPv6 Address], and then [Change Settings]. [. . . ] Select [Manually Configured IPv6 Address], and then [Change Settings]. Use the keypad on the screen to enter an IP Address for the machine in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx". Select [Manually Configured IPv6 Prefix], and then [Change Settings]. [. . . ]