User manual XEROX WORKCENTRE 470CX

[. . . ] To go to a chapter in this book, click on one of the following links. After displaying a chapter, you can click on an entry in the chapter's Table of Contents, or click on the Search button to look for a key word or phrase. To go to a printable copy of this User Guide, click on the Print Preview button on the left. Your WorkCentre 470cx and supplies are designed and tested to meet strict safety requirements. [. . . ] Document Options Each category item, when clicked on, expands to reveal more options. When clicked on, each option opens a second window below the first one, offering additional options. Note: When Paper Size is selected, the second window which When you change a setting, the text turns to red. Change Left Cartridge This feature enables you to install a Color print cartridge in the left position of the print cartridge carrier. Note: The WorkCentre Control Program is not included with Xerox WorkCentre 470cx Control Program Window When the Xerox WorkCentre 470cx Control Program on LPT1 window opens, click the appropriate tab for the options you want to display. This tab shows the printer status, ink levels, and print job status. The information area displays which job is printing, which page and copy, the time, and any alert messages. This tab allows you to specify the Control Program setup options. Run Minimized - Select Run Minimized to prevent the Status tab window from appearing on your computer screen each time you send a job to print. When you select this option, a Status tab icon appears on your screen instead of the Status tab window. Close Status at End of Job - Select Close Status at End Job to close the Control Program when the job is finished printing. â· Sound Effects Enabled - Select Sound Effects Enabled to turn on the sound effects that accompany printer software messages. , these sound effects were enabled when you installed the software. â· Enable Buffer Mode - Select Enable Buffer Mode if your printer pauses frequently (every two or three lines) during a print job, and prints pages with alternating bands of light and dark print. The printer pauses frequently because it is printing data faster than the computer can send it. banded printing occurs when the printer pauses frequently. When you select this option, it takes longer for the first page of a job to begin printing. â· Disable Xerox WC470cx DOS Printing (Enable DOS printing to other printers) - Select this feature when you are using a DOS application to print to a printer other than your Uncheck this option when you are using a DOS application to print to your WorkCentre 470cx. After checking or un-checking this option, you must restart Windows 3. Note: If a Xerox printer and another printer are connected to the Same port on your computer through a switch box or other device, check Disable Xerox WC470cx DOS Printing and restart Windows before switching from one printer to the other. Switching printers without selecting this option may cause printer errors. This tab allows you to view the level of ink in the cartridges and to choose cartridge options. [. . . ] This refers to the printer port found on the back of your machine. This feature lets you reduce machine power when the printer is idle. You can change the length of time the printer waits after a job is printed before power is reduced. The Printer Driver is software that you load into your PC that enables your PC to print a document from its PC application to your printer. [. . . ]