User manual XTA DP226 V3

[. . . ] DP226 Quick Reference Accessing channels: press channel's GAIN button. First press accesses that channel's gain. To scroll through a channels parameters, use the BACK and NEXT keys. Second press accesses last viewed parameter. [. . . ] Changes + Mutes All parameters may be viewed, but none may be adjusted. EVERYTHING No parameters are accessible ­ in effect the GAIN and MUTE keys do nothing. DP224/6 Operators Manual Page 29 Entering the Password to Complete the Locking Operation After selection of the lock type from the list above, a four-digit security code will be asked for. This can be entered by using the `FREQ' control to select a character, and the `BACK' and `NEXT' keys to move to the next character. Alternatively, the `GAIN' keys can be used to enter a code by pressing any combination of the eight buttons. Each `GAIN' key represents its channel labelling, so any combination of A, B, 1, 2, 3, 4, 5 and 6 can be used as a code, as shown below. IMPORTANT - Please note your code!If the security code number is forgotten contact your local XTA sales office. Page 30 DP224/6 Operators Manual System Sub-Menu System Status Displays unit information including software version and temperature. = current temperature in degrees Celsius. LCD Contrast Adjusts the LCD contrast from 0 to 100. LED Brightness Adjusts the LED brightness from 1 to 15. Temperature Alarm Sets a temperature warning between 20 and 80°C. Temp = n°C' when the specified temperature is reached. the warning does not affect the units' performance in any respect. ) Program Update Loads a new version of software from a PC card. Updating the software will not affect any user memories stored in the unit. Wake-up Time Sets how the unit starts up with one of the following options. 0 to 60 seconds: Waits the specified time before unit wakes up. Mute hold: Turns on and holds all output mutes when turned on. Wake-up is a slow ramp in level for about 5 seconds. ) Output Meters Selects whether the output meters are pre or post mute. If the meters are set to read pre-mute, they will still show the level, even if the channel has been muted. Filter Q or BW Selects whether `Q' or Bandwidth is displayed in the parametric screens. Delay Time/Distance Selects whether delay is displayed in milliseconds, metres, or feet. Unit Cloning This option allows a unit to be completely `backed up' or `restored' to another unit. Selects store or recall `clone' data using a PC card. [. . . ] Firstly, choose the format (operation mode) of the interface, or disable it by setting this parameter to the `OFF' position. Use the `BACK' and `NEXT' keys to choose from `COMPLEX', `SIMPLE' or `OFF'. The use of the formats is explained in following sections. `COMPLEX' allows recall of up to the first 31 memories; `SIMPLE' allows the first 7 to be accessed. [. . . ]