User manual XYRON PRO1250

[. . . ] Install the crank handle by carefully threading it clockwise into the threaded opening in the side plate until snug. Cartridge Replacement Slide input tray out away from machine. With both hands, lift and slide output tray away from machine. 1 Input Tray Output Tray With top cover open, lift out used cartridge. Install new cartridge completely and ensure film rests evenly on lower roller. [. . . ] How to Do Single-Sided Lamination Verify that a front-side lamination cartridge (designated SL1200 series on the cartridge label) is installed. Place item on tray with side to be laminated face up. Follow steps 1, 2 & 3 under Basic Operation. How to Apply Adhesive to One Side of an Item Verify that an adhesive transfer cartridge (designated AT1200 series on the cartridge label) is installed. Place the side of the document to which you want adhesive applied face down on the tray. Follow steps 1, 2 & 3 under Basic Operation. Peel away and discard clear plastic protective film. When ready, peel away the white paper liner from the backside of document and mount your item. How to Do Front-Side Lamination with Back-Side Adhesive Application Verify that a laminating/back side adhesive cartridge (designated LAT1200 series on the cartridge label) is installed. Place the side of the document to which you want adhesive applied face down on the tray. The side facing up should be the side you want laminated. Follow steps 1, 2 & 3 under Basic Operation. Peel away the white paper liner from the backside of document prior to mounting. TIP: To save a later trimming operation, turn the crank to advance the document until the leading edge is aligned with the upper blade bar supporting the cut blade. Trim excess material from the leading edge of the document. Continue to crank document through machine and trim when finished. Refill Cartridges Product No. Description Feet (m) Per Roll DL1201-150 SL1201-150 LAT1201-100 LAT1206-100 AT1201-100 AT1202-100 AT1205-100 AT1206-100 Two-Sided Lamination ­ General Use Single-Sided Lamination ­ General Use One Side Laminate / One Side Adhesive Application ­ High Tack One Side Laminate / One Side Adhesive Application ­ Repositionable Adhesive Application ­ High Tack Adhesive Application ­ Low Tack Adhesive Application ­ Acid Free Adhesive Application ­ Repositionable 150' (45. 8 m) 150' (45. 8 m) 100' (30. 5 m) 100' (30. 5 m) 100' (30. 5 m) 100' (30. 5 m) 100' (30. 5 m) 100' (30. 5 m) EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 Troubleshooting Symptom Top and bottom laminating films are not aligned. Film does not exit dispenser between upper and lower blade bars. [. . . ] Material is curled or adhesive has been transferred to the nip roller causing the film to stick Adhesive build-up on idler bars. No pressure between upper and lower nip rollers. Material is not positioned between rollers or laminate is adhered to input tray. [. . . ]