User manual YAMAHA 9.9HP-1999

[. . . ] In this Owner's Manual particularly important information is distinguished in the following ways. The Safety Alert Symbol means ATTENTION!YOUR SAFETY IS INVOLVED! cC A CAUTION indicates special precautions that must be taken to avoid damage to the outboard motor. NOTE: A NOTE provides key information to make procedures easier or clearer. [. . . ] 700~800 S S S mm (in. ) mm (in. ) mm (in. ) mm (in. ) kg (lb. ) 873 (34. 4) 1, 040 (40. 9) 332 (13. 1) 440 (17. 3) 36 (79) Unit 9. 9MSHC V-A (W) Fuel:Oil cm3 (US oz, Imp oz) 4-1 E 15MSHC -- -- 873 (34. 4) 1, 040 (40. 9) 332 (13. 1) 440 (17. 3) 36 (79) 4, 500~5, 500 11. 0 (15) at 5, 000 r/min. 700~800 2-stroke, L2 246 (15. 01) 56 × 50 (2. 20 × 1. 97) C. D. I B7HS-10 0. 9~1. 0 (0. 035~0. 039) Tiller control Manual start 12-(80) Choke valve start system Forward-Neutral-Reverse 2. 08 (27/13) Manual J Regular unleaded gasoline (P. O. N. : minimum 86) 25 (6. 6, 5. 5) YAMALUBE, 2 STROKE OUTBOARD OIL or an equivalent TC-W3 certified outboard oil Premix 100 : 1 Hypoid gear oil (SAE 90) 250 (8. 5, 8. 8) 25 (2. 5, 18) 17 (1. 7, 12) 4-2 E EMU01369 TRANSPORTING AND STORING OUTBOARD MOTOR w Leaking fuel is a fire hazard. When transporting and storing the outboard motor, close the air vent screw and fuel cock to prevent fuel from leaking. TRAILERING OUTBOARD MOTOR The motor should be trailered and stored in the normal running position. If there is insufficient road clearance in this position, then trailer the motor in the tilt position using a motor support device such as a transom saver bar. cC Do not use the tilt support lever/knob when trailering the boat. The outboard motor could shake loose from the tilt support and fall. If the motor can not be trailered in the down position, use an additional support device to secure it in the up position. w 8 Never get under the lower unit while it is tilted, even if a motor support bar is used. Severe injury could occur if the outboard accidentally falls. 8 USE CARE when transporting fuel tank, whether in a boat or car. DO NOT fill fuel container to maximum capacity. Gasoline will expand considerably as it warms up and can build up pressure in the fuel container. This can cause fuel leakage and a potential fire hazard. (Refer to the Periodic Maintenance section, "Changing gear oil. "). Inspect the oil for the presence of water which indicates a leaky seal. Seal replacement should be performed by an authorized Yamaha dealership prior to use. (Refer to the Periodic Maintenance section, "Greasing. ") EMK27010 Cleaning and Anti-corrosion Measure 1) Wash down the exterior of the outboard with fresh water and dry off completely. 2) Spray the engine's exterior with Yamaha Silicone Protectant (Part No. 3) Wax the cowling with a non-abrasive wax such as Yamaha Silicone Wax (Part No. ACC-11000-15-02). 4-6 E EMU01569 PERIODIC MAINTENANCE w Be sure to turn off the engine when you perform maintenance unless otherwise specified. If the owner is not familiar with machine servicing, this work should be done by a Yamaha dealer or other qualified mechanic. Maintenance, replacement, or repair of the emission control devices and systems may be performed by any marine engine repair establishment or individual. All warranty repairs, however, including those to the emission control system, must be performed by an authorized Yamaha marine dealership. A service manual is available for purchase through a Yamaha dealer for owners who have the mechanical skills, tools, and other equipment necessary to perform maintenance not covered by this owner's manual. EMK33011 REPLACEMENT PARTS If replacement parts are necessary, use only genuine Yamaha parts or equivalents of the same type and of equivalent strength and materials. [. . . ] This list is complied from the purchase registrations sent to Yamaha Motor Corporation, U. S. A. by the selling dealer at the time of your purchase. If you should move after you have purchased your new outboard, please advise us of your new address by sending a postcard listing your outboard model name, engine serial number, dealer number (or dealer's name) as it is shown on your warranty identification, your name and new mailing address. Mail to: YAMAHA MOTOR CORPORATION, U. S. A. [. . . ]