User manual YAMAHA AA5

[. . . ] 8 kg (3 lbs 15 oz) *excluding batteries GAccessory : Power adaptor (PA-D09) * Specifications and/or design may change for reasons of improvement without notice. WARNING- When using any electrical or electronic product, basic precautions should always be followed. These precautions include, but are not limited to, the following: This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. [. . . ] All other servicing should be referred to qualified service personnel. Main Power Supply Verification: Yamaha products are manufactured specifically for the supply voltage in the area where they are to be sold. If you should move, or if any doubt exists about the supply voltage in your area, please contact your dealer for supply voltage verification and (if applicable) instructions. the required supply voltage is printed on the name plate. For name plate location, please refer to the graphic found in the Special Message Section of this manual. When connecting this product to accessories and/ or another product use only high-quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in DANGER-Grounding Instructions: This product must be grounded and therefore has been equipped with a three pin attachment plug. If this product should malfunction, the ground pin provides a path of low resistance for electrical current, reducing the risk of electrical shock. Some Yamaha products may have benches and/or accessory mounting fixtures that are either supplied as a part of the product or as optional accessories. Some of these items are designed to be dealer assembled or installed. Please make sure that benches are stable and any optional fixtures (where applicable) are well secured BEFORE using. benches supplied by Yamaha are designed for seating only. , to this input jack (standard monaural phone jack). * Before making connections, set the power switch to its OFF position. R AUX IN: Connect an external audio device such as a CD player, MD player, etc. T LINE OUT: Converts the impedance of the INPUT jack's signal and sends the signal out through this jack (bypassing the TONE circuit). Connecting the signal from this jack to the INPUT jack on another AA5 allows sound output from a 4-speaker system (2x2). Y DC IN: When using an AC power adaptor, connect it here. * Use the supplied AC power adaptor, or an AC power adaptor that delivers DC6-9V/1A or less ( ). [. . . ] In this case, replace the batteries following the cautions below. â· Make sure all batteries are inserted with their poles properly aligned. , or mix different battery types (alkaline, manganese, different manufacturers, different types by the same manufacturer, etc. * When the device is not to be used for an extended period of time, remove the batteries from the unit. [. . . ]