User manual YAMAHA ADD-ON EFFECTS-AE031-

[. . . ] · The software and this Owner's Manual are exclusive copyrights of Yamaha Corporation. · Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. · Yamaha makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for the results of the use of this manual and the software. · The screen displays as illustrated in this Owner's Manual are for instructional purposes, and may appear somewhat different from the screens which appear on your computer. [. . . ] @ 2 [OPEN/CLOSE] Studio Manager Click here to open or close the parameter window. 3 [Reverb Time]/[REV TIME] Studio Manager Console Duration of time until the reverberation attenuates and stops. In Studio Manager, drag the icon to change the value. n The range is from 0. 3s through 30. 0s. However, the range varies depending on the Room Size setting. 4 [Initial Delay]/[INI. DLY] Studio Manager Console Duration of time between sound input and the start of reverberation. Higher values delay the start of reverberation. In Studio Manager, drag the icon to change the value. n The range is from 0. 0ms through 125. 0ms. 5 [Decay]/[DECAY] Studio Manager Console Shape of reverberation envelope. Reverberation characteristics are determined by the value. In Studio Manager, drag the icon to change the value. n The range is from 0 through 53. 4 2 3 4 5 6 7 3 7 8 4 6 9 ) 5 !@ 6 [Room Size]/[ROOMSIZE] Studio Manager Console Size of space. This value is linked with the Reverb Time value. When you change this value, the Reverb Time value changes. In Studio Manager, drag the icon to change the value. n The range is from 0 through 28. 7 [Diffusion]/[DIFF. ] Studio Manager Console Density and spread of reverberation. Higher values increase the density and enhance the spread. In Studio Manager, drag the icon to change the value. n The range is from 0 through 10. 8 [HPF] Studio Manager Console This filter cuts the low frequency range of the reverberation. The range below the frequency specified by this value is cut. This filter does not affect the original source sound. In Studio Manager, drag the icon to change the value. n The range is Thru to 8. 00kHz. 9 [LPF] Studio Manager Console This filter cuts the high frequency range of the reverberation. The range above the frequency specified by this value is cut. This filter does not affect the original source sound. [. . . ] The curve changes depending on the Reverb Time, Hi Ratio, and Lo Ratio parameter values. 6 ^ & *( ^ [Auto Zoom] button Click the Studio Manager button to automatically adjust the time axis (horizontal axis). Studio Manager & Time Axis Set button Use this button to specify the time duration (in seconds) as displayed by the time axis (horizontal axis). *[ ] (Zoom Out) button Studio Manager Click this button to increase the time value (in seconds) as displayed by the time axis (horizontal axis). As a result, the display zooms out on the horizontal axis. ([ ] (Zoom In) button Studio Manager Click this button to decrease the time value (in seconds) as displayed by the time axis (horizontal axis). As a result, the display zooms in on the horizontal axis. º 6 º º [OUTPUT] meter/Level meter Studio Manager Console Studio Manager displays the Effects output level. On the console, you can select the input level or output level to be displayed using the METER: [IN][OUT] switch. ¡ *( ¡ ¡ [MIX] slider/[MIX BALANCE] control Studio Manager Console These controls enable you to adjust the mix balance of the dry and wet (effect) sounds. [. . . ]