User manual YAMAHA AVX-700

[. . . ] To prevent fire or electrical shock, do not place this unit where it may get exposed to rain, water, and/or any type of liquid. Do not expose this unit to sudden temperature changes from cold to hot, and do not locate this unit in a environment with high humidity (i. e. a room with a humidifier) to prevent condensation inside this unit, which may cause an electrical shock, fire, damage to this unit, and/or personal injury. On the top of this unit, do not place: ­ Other components, as they may cause damage and/or discoloration on the surface of this unit. [. . . ] If the "EON" indicator does not light up, tune in to another RDS station so that the "EON" indicator lights up. Lights up PS PTY RT CT · When broadcasting of the required program ends, the previously received station (or another program on the same station) is recalled. PS PTY RT CT BASIC OPERATION EON BASS EXT. TUNED AUTO STEREO AB I To cancel this function AUTO STEREO EON BASS EXT. TUNED Press EON repeatedly until no program type name lights up on the display. ADVANCED OPERATION AB APPENDIX English 33 RECORDING A SOURCE Recording adjustments and other operations are performed from the recording component. Refer to the instructions for these components. Notes · Do a test recording before you start an actual recording. · When this unit is set in the standby mode, you cannot record between other components connected to this unit. · The DSP program and the setting of VOLUME, BASS, TREBLE and BALANCE have no effect on the material being recorded. · A source connected to the 6CH INPUT jacks of this unit cannot be recorded. · Composite video and S video signals pass independently through this unit's video circuits. Therefore, when recording or dubbing video signals, if your video source component is connected to provide only an S video (or only a composite video) signal, you can record only an S video (or only a composite video) signal by your VCR. · A given input source is not output on the same REC OUT channel. (For example, the signal input from VCR 1 IN is not output on VCR 1 OUT. ) · Check the copyright laws in your country to record from records, CDs, radio, etc. The entire range of the center channel signal is directed to the center speaker. SML Select this if you have a small center speaker. The lowfrequency signals (90 Hz and below) of the center channel are directed to the speakers selected with "BASS OUT". NON Select this if you do not have a center speaker. All of the center channel signals are directed to the left and right main speakers. y · This unit is set in the Virtual CINEMA DSP mode by selecting NON for "REAR LR SP". 36 SET MENU I BASS OUT (bass out mode) LFE signals carry low-frequency effects when this unit decodes a Dolby Digital or DTS signal. Low-frequency signals are defined as 90 Hz and below. Choices: SWFR (subwoofer), MAIN, BOTH Initial setting: BOTH 2 HP TONE CTRL (headphone tone control) Use this feature to adjust the level of the bass and treble when you use your headphones. Control range (dB): ­6 to +3 Initial setting: 0 dB for both BASS and TRBL (treble) INTRODUCTION SWFR Select this if you use a subwoofer. The LFE signals are directed to the subwoofer. MAIN Select this if you do not use a subwoofer. The LFE signals are directed to the main speakers. [. . . ] 37 I IMPEDANCE SELECTOR switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 INPUT MODE (SET MENU) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Input modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 I/O ASSIGN (SET MENU) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]