User manual YAMAHA BANSHEE-1999

[. . . ] This manual includes important safety information. It provides information about special techniques and skills necessary to ride your ATV. It also includes basic maintenance and inspection procedures. If you have any questions regarding the operation or maintenance of your ATV, please consult a Yamaha dealer. AN IMPORTANT SAFETY MESSAGE: 8 READ THIS MANUAL TOGETHER WITH TIPS FOR THE ATV RIDER CAREFULLY AND COMPLETELY BEFORE OPERATING YOUR ATV. [. . . ] This maneuver will let the wheel on the inside of the turn slip slightly, allowing the ATV to make the turn properly. qWARNING POTENTIAL HAZARD Turning improperly. WHAT CAN HAPPEN The ATV could go out of control, causing a collision or overturn. 7-23 Lean towards inside of turn. Support your weight on the outer footboard. Once you have learned this technique you should be able to perform it at higher speeds or in tighter curves. Improper riding procedures such as abrupt throttle changes, excessive braking, incorrect body movements, or too much speed for the sharpness of the turn may cause the ATV to tip. If the ATV begins to tip over to the outside while negotiating a turn, lean more to the inside. It may also be necessary to gradually let off on the throttle and steer to the outside of the turn to avoid tipping over. Remember: Avoid higher speeds until you are thoroughly familiar with the operation of your ATV. This procedure should be practiced at slow speed many times in a large off-road area with no obstacles. If an incorrect technique is used, your ATV may continue to go straight. If the ATV doesn't turn, come to a stop and then practice the procedure again. If the riding surface is slippery or loose, it may help to position more of your weight over the front wheels by moving forward on the seat. 7-24 CLIMBING UPHILL Use proper riding techniques to avoid vehicle overturns on hills. Be sure that you can maneuver your ATV well on flat ground before attempting any incline and then practice riding first on gentle slopes. Try more difficult climbs only after you have developed your skill. WHAT CAN HAPPEN Could result in the ATV overturning. HOW TO AVOID THE HAZARD Use proper gear and maintain steady speed when climbing a hill. If you lose all forward speed: Keep weight uphill. Lock the parking brake, after you are stopped. If you begin rolling backwards: Keep weight uphill. Never apply the rear brake while rolling backwards. Apply the front brake. 7-28 When fully stopped, apply the rear brake as well, and then lock the parking brake. Dismount on uphill side or to a side if pointed straight uphill. Turn the ATV around and remount, following the procedure described in the Owner 's Manual. 7-29 RIDING DOWNHILL When riding your ATV downhill, shift your weight as far to the rear and uphill side of the ATV as possible. Move back on the seat and sit with your arms straight. Choose a low gear which will allow the engine compression to do most of the braking for you. [. . . ] However, if a particular failure is caused by operation or maintenance other than as shown in the Owner's Manual, that failure may not be covered under warranty. What responsibility does my dealer have under this warranty?Each Yamaha ATV dealer is expected to: 1. Completely set up every new machine before sale. [. . . ]