User manual YAMAHA BCS20W-150

[. . . ] Retain this Owner's Manual in a safe place for future reference. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS 1 2 3 4 5 6 7 Read Instructions ­ All the safety and operating instructions should be read before the product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. Heed Warnings ­ All warnings on the product and in the operating instructions should be adhered to. Follow Instructions ­ All operating and use instructions should be followed. [. . . ] 13 ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY (for YST-SW005) . . . . . . . . . . . . . . . . 14 TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 E-2 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 English SETTING UP THE SPEAKERS Before making connections, place all speakers in their respective positions. The positioning of the speakers is important because it controls the whole sound quality of this system. Place the speakers depending on your listening position by following the instructions below. Speaker configuration <NS-P230> This speaker package employs a 6 speaker configuration: 2 main speakers, 2 rear speakers, a center speaker and a subwoofer. The main speakers emit main source sound. The rear speakers emit surround sounds, and the center speaker emits center sounds (dialog etc. ). The subwoofer emits reinforcing low frequencies on your audio system. Placing speakers Main speakers: Rear speakers: On both sides of and at approximately the same height as the TV set. Behind your listening position, facing slightly inward. Precisely between the main speakers. Center speaker: Rear center speaker (for NS-P236): Precisely between the rear speakers. 20 mm To mount the speakers on a wall by using the holes on the speakers' back panels 2 1 2 Fasten screws into a firm wall or wall support as shown in the figure. Hang the speaker by mounting the holes on the protruding screws. * Make sure that the screws are securely affixed by the narrow parts of the holes. 70 mm Using the Yamaha Speaker Stand SPS-80 (option) By using the Yamaha Speaker Stand SPS-80, speakers can be placed on the floor. WARNING Each speaker weighs 0. 9 kg (2 lbs. ). Do not mount them on thin plywood or a wall composed of a soft surface material. If mounted, the screws may pull out of the flimsy surface and the speakers may fall. This may damage the speakers or cause personal injury. Do not affix the speakers to a wall using nails, adhesives, or any other unstable hardware. Longterm use and vibrations may cause the speakers to fall. To avoid accidents resulting from tripping over loose speaker cables, fix the cables to the wall. Select an appropriate position on the wall to mount the speaker so that no one will injure his/her head or face. SPS-80 * The SPS-80 is not available in some areas. E-5 I Placing the the main/rear speakers (and rear center speaker for NS-P236) When placing the speakers on a flat surface, attach the included nonskid pads to the corners on the bottom of the speakers as shown on the left. This prevents the speakers from sliding around. [. . . ] 30W Maximum Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100W Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Frequency Response <NX-230P> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 Hz to 30 kHz <NX-C230> . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]