User manual YAMAHA C60-1998

[. . . ] In this Owner's Manual particularly important information is distinguished in the following ways. The Safety Alert Symbol means ATTENTION!YOUR SAFETY IS INVOLVED! EWM00780 al, please consult your Yamaha dealer. NOTE: The ZC60-1998TR, LZC60-1998TR and the standard accessories are used as a base for the explanations and illustrations in this manual. Therefore some items may not apply to every model. EMU25110 WARNING Failure to follow WARNING instructions could result in severe injury or death to the machine operator, a bystander, or a person inspecting or repairing the outboard motor. ECM00700 ZC60-1998, LZC60-1998 OWNER'S MANUAL ©2006 by Yamaha Motor Corporation, USA 1st edition, April 2006 All rights reserved. [. . . ] For the optional sensor, consult your Yamaha dealer. The speed & fuel meter unit is available in round or square types. Check your speed & fuel meter unit type. 1. Multifunction display 1 2 ZMU05434 1. Mode button 31 Basic components 1 2 1 3 1. Multifunction display ZMU05435 2 ZMU05436 1. Mode button NOTE: After the main switch is first turned on, all the displays come on as a test. After a few seconds, the gauge will change to normal operation. 1 3 NOTE: The speed & fuel meter unit shows various kinds of information according to the setting made with the " " (set) and " " (mode) buttons. For details, see the attached operation manual. EMU31620 2 ZMU05437 1. Multifunction display Speedometer unit This unit shows the boat speed and has functions of fuel meter and system voltage display. If optional sensors are connected to the unit, trip display, water surface temperature display, depth display, and clock will be available. G For portable models, your dealer or other person experienced in proper outboard motor mounting should show you how to mount your motor. Mount the outboard motor on the center line (keel line) of the boat, and ensure that the boat itself is well balanced. Otherwise the boat will be hard to steer. For boats without a keel or which are asymmetrical, consult your dealer. NOTE: During water testing check the buoyancy of the boat, at rest, with its maximum load. Check that the static water level on the exhaust housing is low enough to prevent water entry into the powerhead, when water rises due to waves when the outboard is not running. EMU26910 Mounting the outboard motor EWM00820 WARNING G G Overpowering a boat could cause severe instability. Do not install an outboard motor with more horsepower than the maximum rating on the capacity plate of the boat. If the boat does not have a capacity plate, consult the boat manufacturer. The information presented in this section is intended as reference only. It is not possible to provide complete instructions for every possible boat and motor combination. Proper mounting depends in part on experience and the 1 1. Center line (keel line) ZMU01873 36 Operation board motor is affected by the boat/motor combination and the desired use. [. . . ] Firmly screw the filter cup onto the filter housing. gine oil tank using the emergency switch. EWM01050 WARNING Be sure to stop the engine before performing this procedure. ECM00900 NOTE: Be careful not to twist the water detection switch lead when screwing the filter cup onto the filter housing. Connect the water detection switch coupler securely until a click is heard. CAUTION: G G If the emergency switch is held up too long, too much oil will be pumped into the engine oil tank, overflowing it. Release the switch when oil reaches the upper level line on the engine oil tank. [. . . ]