User manual YAMAHA CLP-157

[. . . ] SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. [. . . ] ZTo restore the default pitch (A3 = 440 Hz), hold the A-1, A#-1, and B-1 keys simultaneously and press any key between C3 and B3, or simultaneously press the TEMPO [s] and [t] buttons. q To Restore Standard Pitch A#-1 A -1 B -1 C3 B3 X Release the A-1, A#-1 and B-1 keys. NOTE w TEMPO · Hold either the TEMPO [s] or [t] button for continuous scrolling in the specified direction. · The PITCH CONTROL function has no effect when LOCAL OFF is active (see "MIDI FUNCTIONS, " page 20). v q The Pitch Display Example: 442 4. 42 44. 2 442. 442. 0 . . . . . . . . . 442. 99 The approximate pitch of A3 is shown on the TEMPO display in Hertz while the pitch control function is in operation. The total display range is from approximately 427 hertz (-50 cents) to 453 hertz (+50 cents). The dots to the right of each figure in the display are used to provide a general idea of fractional pitches. q Memorizing the Pitch Control Setting C7 Press the C7 key while holding the A-1/B-1, A-1/A#-1, or A-1/A#-1/B-1 key combination to memorize the current pitch control setting. The memorized setting will be retained in memory for about one week after the power is turned off, then the standard pitch will be restored. To keep the memorized setting for longer periods, turn the power on briefly at least once a week. If this setting is not memorized as described above, it is retained in memory only until the Clavinova is turned off. 12 The Metronome & Tempo Control The CLP-157 built-in metronome is a convenient feature for practice, and it can also provide a solid rhythmic guide when recording using the Recorder feature, described below. The Metronome METRONOME The metronome sound is turned on and off via the [METRONOME] button. Press the [METRONOME] button so that its indicator lights to turn the metronome on and then again so that the indicator goes out to turn the metronome off. When the metronome is on the current measure number is shown on the TEMPO display. The volume of the metronome sound can be independently adjusted by using the TEMPO [s] and [t] buttons while holding the [METRONOME] button. The first time either button is pressed the current volume setting appears on the TEMPO display, then pressing the [s] button increases the volume while the [t] button decreases the volume. Press both the [s] and [t] buttons simultaneously to instantly recall the default ("8") setting. s A setting of "1" sets the minimum metronome volume. s A setting of "8" sets the default metronome volume. s A setting of "15" sets the maximum metronome volume. NOTE q Metronome Volume 8 METRONOME w TEMPO v · Hold either the TEMPO [s] or [t] button for continuous scrolling in the specified direction. q Metronome Time Signature PIANO 1 PIANO 2 PIANO 3 CLAVINOVA E. PIANO 1 TONE The time signature of the metronome sound can be set by pressing the appropriate voice selector button while holding the [METRONOME] button, as follows: METRONOME Beat Indicator No accent/ 4 time 2 time 1st 2nd 3rd 4th 5th 6th Beat Beat Beat Beat Beat Beat 1. 20 3 time 6 time [METRONOME] + [PIANO 1] [METRONOME] + [PIANO 2] [METRONOME] + [PIANO 3] [METRONOME] + [CLAVINOVA TONE] [METRONOME] + [E. PIANO 1] No accent (default) 2 time 3 time 4 time 6 time The dots on the TEMPO display flash to indicate the current beat within the current measure, as shown to the left. Tempo Control 120 w TEMPO v The tempo of the Metronome and Recorder playback functions can be adjusted from 32 to 280 quarter-note beats per minute via the TEMPO [s] and [t] buttons. The current tempo normally appears on the TEMPO display. Although the TEMPO display shows the current measure number during Metronome or Recorder operation, the tempo value is displayed when either of the TEMPO buttons are pressed, and remains on the display for about one second after the TEMPO buttons are released. The default tempo of 120 beats per minute is automatically set when the power is initially turned on. Press the TEMPO [s] and [t] buttons simultaneously to instantly recall the default tempo (120) at any time. [. . . ] NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices. Compliance * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. with FCC regulations does not guarantee that interference will not occur in all installations. [. . . ]