User manual YAMAHA CRW2200S

[. . . ] (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party: Address: Telephone: Fax: Type of Equipment: Model Name: Yamaha Electronics Corporation, USA 6660 Orangethorpe Avenue Buena Park, CA 90620 714-522-9105 714-670-0108 CD Recordable/Rewritable Drive CRW2200 CRW2200NB This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. FCC INFORMATION (U. S. A. ) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! [. . . ] Do not use excessive force when installing. Otherwise, it may cause damage. 1 Shut down your computer and unplug it from the AC outlet. 14 step 1) ¡ 2 Remove all attached cables and peripheral devices and the outer casing of the computer. If you need to remove screws in the process, make sure you don't lose them. Remove the cover and front panel of the computer. 14 step 2) ¡ 3 Touch a metal part of the computer's chassis or power supply unit to discharge any static electricity from your body. Or, wear an anti-static grounding wrist strap. 15 step 3) ¡ 32 Removing the SCSI convertor 4 Disconnect all cables connected to the CRW2200S and remove it from the computer. If the audio cable is connected to the CRW2200S, disconnect the sound card's side connector only. Audio cable 50-pin SCSI flat cable 4-pin power cable 5 Remove the screw securing the SCSI convertor to the CRW2200 drive. Screw 33 Removing the SCSI convertor 6 Remove the SCSI convertor from the CRW2200 drive. SCSI convertor 7 Disconnect the power cable from the SCSI convertor and the CRW2200 drive. The smaller connector connected to the SCSI convertor is locked with its hook. Lift up the connector to unlock the hook, then pull it out. (See the figure below. ) If the audio cable is connected, disconnect it after removing the convertor. (An analog audio cable connection is shown in the figure below. ) Analog audio cable Smaller connector Bigger connector Power cable 34 E-IDE (ATAPI) Connection Set Up If the CRW2200S has already been installed to the computer by SCSI connection, remove it from the computer and detach the SCSI convertor. 32 ­ 34) Tools Phillips Screwdriver You will need to use this when removing the cover of your computer and when mounting the drive. You may also need to temporarily remove the sound card to gain access to the CD audio connectors, in which case, a small screw retaining the sound card's face plate has to be removed. Note Make sure your phillips screwdriver's head is the correct size for the screws you need to remove. Long-Nosed Pliers You will need these to insert or remove the plastic shunts when setting the jumper switches at the back of the CRW2200 drive. 35 E-IDE (ATAPI) Connection Set Up CRW2200E Setup Flowchart For easy cross-referencing, the relevant pages in this manual are given. STEP 1 STEP Does your computer have a SCSI connection with the drive? No YES Remove the SCSI convertor. 32 ­ 34) ¡ 2 Connecting the CRW2200E (¡P. Choosing the Connecting Method (¡P. 43) ¡ STEP 3 STEP Configuring for the Operating System (¡P. Check that the CRW2200E is recognized correctly. 48) ¡ 4 STEP Installing the CD Writing Software For details about how to install the software, refer to the documentation that came with it. Start Using the CRW2200E! Use the drive to create audio CDs, to back up data on your hard disk, or for whatever purpose suits your needs. 5 36 E-IDE (ATAPI) Connection Set Up Connecting the CRW2200E This section describes how to connect the CRW2200E by E-IDE (ATAPI) to a tower type computer. In this description, about some parts that is duplicated with the part of "Connecting the CRW2200S" in "SCSI Connection Set Up" (¡P. 14 ­ 31), see the reference page described here. Note The way of removing the casing or panel, or installing built-in devices may differ from your computer. [. . . ] 1, 10, 18, 34 SCSI driver. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 SCSI ID number. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10, 26 Secondary. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Serial Number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]