User manual YAMAHA CRX-M5

[. . . ] glish UCAB CRX-M5 CD Changer Receiver Ampli-Tuner/CD OWNER'S MANUAL MODE D'EMPLOI SAFETY INSTRUCTIONS 6A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN 7 CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. · Explanation of Graphical Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 8 9 10 11 WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. 12 13 IMPORTANT! [. . . ] However, if signals of the desired station signal is weak, you must tune to it manually. 4 The unit starts searching for a station. TUNED STEREO English CH MHz Station frequency When the unit finds a station, the unit stops searching and "TUNED" appears in the display. 5 POWER / CT TIMER CLOCK SET RDS TIME PTY REP RT EDIT TUNING If the located station is not the desired one, repeat steps 3 and 4 until your desired station is heard. TUNING / /? DISC Notes · If automatic tuning search does not find the desired station, try manual tuning as described below. · When an FM stereo broadcast with sufficient signal strength is received, "STEREO" appears in the display and you can listen to stereo sound. FM/AM ST/MONO 1 MEMORY PGM PRESET 2 3 FM/AM / TUNER CD 1 2 3 4 5 6 REC/ PAUSE / 7 REC/ MUTE 8 CD SYNC 9 0 +10 TAPE Manual tuning 1 VOLUME MD INPUT SLEEP MUTE Follow steps 1 and 2 described in "Automatic tuning. " Press TUNING / (for a higher frequency) or ?(for a lower frequency) to select your desired station. · Each time you press TUNING / or ?, the frequency changes step by step. ­ + INPUT 2 Note · If an FM program is noisy, press ST/MONO so that "STEREO" disappears from the display. There will be no stereo effect, but the reception will improve. Press this button again to restore the stereo effect. Automatic tuning 1 2 Press INPUT so that the frequency of the radio station appears in the display. Press FM/AM to select the reception band. STEREO One touch play You can switch from another source to the radio just by pressing FM/AM. In this case, the unit tunes to the last received station. CH MHz Selected band Using the //?buttons on the front panel work as the TUNING //?To change a part, press TUNING/PRESET on the front panel. Each time you press TUNING/PRESET, the item changes. 3 Press and hold TUNING / (for a higher frequency) or ?(for a lower frequency) for more than 2 seconds, then release the button. E-13 TUNER OPERATIONS Presetting stations The unit can preset station frequencies selected by Automatic tuning or Manual tuning. With this function, you can select any desired station by pressing the corresponding preset station number. Up to 30 stations can be stored. 3 Within 5 seconds, use the number buttons to select a desired preset number. (Example: To select 25, press +10 twice so that "2 ­" appears in the display, then press 5. ) TUNED MEMORY STEREO CH MHz Selected preset number POWER / CT TIMER CLOCK SET You can also select a preset number by using PRESET //?. PRESET //? RDS TIME PTY REP RT EDIT TUNING FM/AM ST/MONO DISC 4 5 Press MEMORY. Repeat steps 1 to 4 until all desired stations are preset. 1 MEMORY PGM PRESET 2 3 / TUNER CD 1 2 3 4 5 MEMORY 9 0 6 REC/ PAUSE / 7 REC/ MUTE 8 CD SYNC Notes +10 TAPE MD · A new setting can be preset in place of the previous one. · The preset stations are retained when you disconnect the AC power cord or a power failure occurs. INPUT SLEEP MUTE VOLUME ­ + To recall a preset station 1 2 Press FM/AM to select the desired band. Press the number button to select a desired preset number. You can also select a preset number by using PRESET //?. To preset stations 1 Tune in a desired station. (Refer to the previous page for the tuning procedure. ) Press MEMORY. TUNED MEMORY STEREO 2 CH MHz The frequency to preset Preset number flashes. E-14 Getting Started Playing CDs RECEIVING RDS STATIONS (U. K. and Europe models only) What is RDS? RDS (Radio Data System) is a data transmission system gradually being introduced by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal. [. . . ] 530 ­ 1720 kHz [U. K. , Europe, Australia, Singapore, and General models] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 522 ­ 1611 kHz Sensitivity FM (S/N 30dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 dB AM (S/N 20dB) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . and Canada models] . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]