User manual YAMAHA CS-30L-CS-30-CS-10 SYNTHESIZER PATCH CHARTS IMAGE

[. . . ] The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Warning: Do not attempt to recharge, disassemble, or incinerate this type of battery. Dispose of used batteries promptly and as regulated by applicable laws. [. . . ] Select the waveform used by the LFO and set the speed of change. LFOíWave) EL1234 Wave^ tri Speed 63 KeySync on AMP Scale (AMP Scaling Offset) AMPíScale)Ofst1 EL1234 +0 Ofst2 +127 Ofst3 -128 Ofst4 +0 s Wave Select the LFO waveform used to vary the sound. There are three waveforms available. t Settings: saw, tri, squ saw (sawtooth wave) s Ofst1/Ofst2/Ofst3/Ofst4 (Offset 1/2/3/4) Set the Amplitude Scaling Offset Levels. These Offsets are used by the Break Points (BP1/BP2/BP3/BP4). Details about Amplitude Scaling are given later in the section "Amplitude Scaling Settings. " t Settings: Ofst1 to Ofst4: -128 ~ 0 ~ +127 Amplitude Scaling Settings By way of example, you could set the Levels (Offsets) and Break Points (BP1 to 4) as follows. AMPíScale) EL1234 BP1 E1 BP2 B2 Ofst2 + 10 BP3 G4 Ofst3 + 17 BP4 A5 Ofst4 +4 tri (triangle wave) AMPíScale)Ofst1 EL1234 -4 squ (square wave) Here, the current amplitude is 80. The Offsets are ­4 at BP1 (set to note E1), +10 at BP2 (set to note B2), +17 at BP3 (set to note G4) and +4 at BP4 (set to A5). That is, the amplitudes at each Break Point are 76, 90, 97 and 84, respectively. For other notes, the amplitudes will be on the straight line connecting the two adjacent Break Points. The Break Points are automatically arranged in ascending order across the keyboard. For example, BP2 cannot be set to a lower note than that of BP1. 100 s Speed Set the speed of the LFO waveform. A larger setting means a faster speed. t Settings: 0 ~ 63 Speed = Fast s AMod (Amplitude Modulation Depth) Set the amount (depth) by which the LFO waveform varies (modulates) the amplitude of the sound. A larger setting means a larger modulation depth. t Settings: 0 ~ 127 Voice Mode Element EQ (Equalizer) Time You can set the following two Equalizer parameters for each Element. EQ Type EQ Param (EQ Parameter) Speed = Slow EQ Type Time EQíType) EL1-3* Type EQ L/H s KeySync Switch Key Sync on or off. Details are given on Page 81. QED EffectCtrl (Quick Edit Effect) Number Ctgry 001[PF:Grand 1 ] Type wave Drum Key settings OSCíWave) Key=C 3 Drum Key SHIFT PAGE A B C 1 2 DATA Most parameters and settings have already been explained for Normal Voices. Details are given on Page 81. QED Filter (Quick Edit Filter) Most parameters and settings have already been explained for Normal Voices. Details are given on Page 82. PART/ELEMENT Menu Display The following is displayed if you turn the [PAGE] knob while holding down the [SHIFT] key. The menus for the settings are shown below. Use the [PAGE] knob to move the cursor to the item you are looking for. Then release the [SHIFT] key to jump to the screen at which you were previously editing the item. Cursor EFFíEF1) Common Com:>GENQED>ARP>CTL Key:>OSC>PCH>FLT>AMP >EFF >EQ QED EG (Quick Edit Envelope Generator) The EG (Envelope Generator) can be used to set the transition in the Drum Voice output level over time. The EG has two parameters determining how the output level of the sound changes from the point at which a note is pressed to the point at which the sound has completely faded out. QEDíEG) Common Attack +63 Decay +63 SHIFT PAGE A B C 1 2 DATA The [PROGRAM/PART] keys on the CS6x can directly select Menus associated to them (Page 80). Attack Decay 103 Voice Mode Drum Key Pitch PCH Tune (Pitch Tune) Drum Key Filter FLT Cutoff (Filter Cutoff) Drum Key Amplitude AMP AEG (Amplitude Envelope Generator) AMP VelSens (Amplitude Velocity Sensitivity) Drum Key EQ (Equalizer) EQ Type (EQ Type) EQ Param (EQ Parameter) 106 106 106 106 106 107 107 101 101 101 Drum Common General For Drum Voices, there is only the one type of Common General parameter shown below. The parameter settings is the same as for Normal Voices. GEN Name (General Name) s Attack Set the Attack time (the time from the moment the note is pressed to the point at which the maximum sound output level is reached). The [ATTACK] knob on the CS6x front panel can also be used to directly adjust the Attack time. t Settings: -64 ~ 0 ~ +63 Voice Mode Drum Key OSC (Oscillator) You can change your Drum Voice waveform settings. Each Drum Voice can consist of up to 73 Drum Keys (Page 37), assigned to notes spread across the keyboard (C0 to C6). [. . . ] Levér det brugte batteri tilbage til leverandoren. VARNING Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enlight fabrikantens instruktion. As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The wire which is coloured GREEN-and-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or colored GREEN or GREEN-and-YELLOW. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. [. . . ]