User manual YAMAHA DRX-1

[. . . ] U DVD Recorder Enregistreur de DVD DRX-1 OWNER'S MANUAL MODE D'EMPLOI CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. CAUTION: To prevent electric shock, match wide blade of plug to wide slot, and fully insert. ATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de a prise et pousser jusqu'au fond. This "bolt of lightning" indicates uninsulated material within your unit may cause an electrical shock. [. . . ] 12 Enter the End time with w/v (down/up cursor) or the digit buttons 0-9. 13 To choose AM or PM, press SELECT when the cursor is on the End time. 14 Press u (right cursor) to move to Record mode. 15 Select the recording mode with w/v (down/up cursor). The recorder will not warn if you program a longer timer recording than possible in the selected record mode from the present disc position. RECORDING 27 English 16 If you make a mistake, go back with t (left cursor) and re-enter the information. When all information is correct, the data is stored in a timer block. 19 Make sure you inserted a disc without write protection. If you inserted a write protected disc, recording will not occur. 20 Turn the Recorder to standby mode by pressing POWER (B/I). Checking or altering a Timer Recording 1 Press TIMER on the remote control. 2 Select `Timer list' with w/v (down/up cursor). Timer VCR Plus+ system Timer programming Timer list If a timer recording is incorrect The following messages may appear in the timer menu when you set a timer recording: Collision The Timer recording overlaps with another timer recording. Solution: Ignore by pressing TIMER again. The program with the earlier start time will record completely. Then the remainder of the later program will record. Please enter channel number The VCR Plus+ system does not recognize the TV channel. Solution: Select the required channel number with t/u (left/ right cursor). PlusCode number wrong You entered an incorrect PlusCode number. Solution: Enter the correct information or quit by pressing TIMER. Weekend programming - not possible Date was incorrectly entered. Daily programming can only be used for recordings from Mondays to Fridays. Memory full All the timer blocks are in use. Solution: Delete one of the Timer recordings. Clock not set-check Clock channel The clock is not set. [. . . ] 1045, 1063, 1064, 1067, 1068, 1069 Envision . 1000, 1006, 1016, 1017, 1021, 1077 Magnavox . 1002, 1006, 1007, 1060, 1064, 1066 Minutz. 1003, 1005, 1009, 1010, 1046 Multitech . [. . . ]