User manual YAMAHA DTX540K ASSEMBLY MANUAL

[. . . ] Always assemble this product with adult supervision. · Be careful with the edges of the Cymbal Holders and the Tom Holders. The sharp holder ends may result in injury. [. . . ] Also, never place any heavy or sharp objects on the cable. Applying excessive force to the cable may result in damage to the cable, such as the wires being severed, etc. · Do not step on or place heavy objects on the product. · Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or high humidity (bathroom, outside on a rainy day, etc. ). Doing so may result in deformation, discoloration, damage or deterioration. · When cleaning the product, do not use benzine, thinner or alcohol as it may result in discoloration or deformation. Please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the product is soiled or sticky, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out thoroughly to remove any remaining detergent. Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product; doing so may result in deterioration. Left leg b Left leg b * Specifications and descriptions in this owner's manual are for information purposes only. reserves the right to change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer. Continued on other side Mounting snare and tom pads DTX540K: XP70 DTX520K: TP65 Assembling the kick pad 2. Mount the snare pad on the rack's clamp rod. As shown below, ensure that the rod section is fully inserted into the pad's mounting hole, and then fully tighten the clamp bolt. Clamp rod Rod section Snare pad Mounting the tom pad 1. 1. If a drum mat (sold separately) is not available, lay a sheet of cardboard on the floor to protect it from scratching. and line up each set nearby in the order in which it was removed. Spring washer Wing bolt Washer As with the snare pad, attach the clamp bolt to each of the three tom pads and provisionally tighten (by 5 or 6 turns). [. . . ] When mounted, the stopper's pin should rest inside the pad unit's smaller hole. * If you were to play a cymbal pad without the stopper's pin positioned inside the smaller hole, the pad could rotate, causing the cable to be pulled out. It is very important, therefore, to ensure that the stopper is secured as described in Step 5 above. Excessive bending can damage the pad cables. Ensure, therefore, that these cables are not bent at an extreme angle when wrapped around the clips. 6 1. Connect the drum trigger module to a power supply. Module stand fastening screws Module stand Drum trigger module (back side) 3. [. . . ]