User manual YAMAHA DTXPLORER BASIC SET ASSEMBLY MANUAL

[. . . ] Do not step on or place heavy objects on the product. Be careful around pipe ends, inside the pipe and screw ends. Do not put your hands or feet under the foot pedal or foot switch. They may be pinched, resulting in injury. [. . . ] Hold the upper area of the vertical pipe and , and shake them. If the rack system is unstable, retighten the knobs tightened in steps 2 to 5. 9-channel snake cable (1) Figure 5: Rack Assembly-3 Instruction Manual (4) - TP65/65S - PCY65/65S - HH65 - KP65 PRECAUTIONS Before using, please read this assembly manual, and use this product in a safe and proper manner. Particularly in the case of children and young users, parents or an instructor should teach the children the proper manner in which to use the device. *1 Use fastening screws to attach the trigger module in " Mounting the pads and the trigger module on the rack system". *2 Use cable bands to bind cables to pipes in " Connecting to a power source". (Spare bands are included. ) *3 Not this manual. Figure 7: Trigger Module DTXPL (1) AC Adaptor (1) WARNING If this symbol is ignored and the equipment is used improperly, fatal injury to persons or serious damage could occur. Assembling the Rack System 1 Take out the rack system from the package and remove all the cushioning. Remove the bubble wrap on the pipes while assembling the rack system. Do not let small children assemble or set up this product by themselves, or they may be injured. Always assemble this product with adult supervision. Be careful with the edges of the cymbal holders and the tom holders. The sharp holder ends may result in injury. Be careful with the edges of the spurs attached to the base. The sharp spur ends may result in injury. If this product is used with the rack system or a cymbal stand, make sure all bolts are tightened firmly. Also, when adjusting the height or angle, do not suddenly loosen the bolts. Loose bolts may result in the rack overturning or parts dropping, causing injury. Always set the product on a flat and solid surface. Placement on a sloping, unstable surface or on steps may result in the product being unstable and subject to overturning. When setting the product, please pay close attention to the handling and setting of cables. Carelessly placed cables may cause the user and others to trip and fall. Doing so may result in injury or damage/deterioration to the product. The rack may overturn or be damaged, resulting in injury. The pipe ends may injure your fingers. [. . . ] Place the KP65 (Kick pad) with FP6110A (Foot pedal) (^3) at the bottom center of the RS40 (rack system). Figure 19: KP65 Assembly 3 4 5 6 ^1 TP65 (Hi-hat cymbal) ^2 HH65 (Hi-hat controller) ^3 KP65 (Kick pad)+ FP6110A (Foot pedal) &1 Power supply jack (DC IN 12V) &2 Cable clip &3 Power switch 1 Make sure to turn the power off (the Standby/ On switch (&3) is set to the standby position). Attach the TP65 (Drum pad) to the tom holder as shown in Figure 11. Tighten the clamp bolt and attach the drum pad TP65 firmly. Loosen the knob (shown with ) of the tom holder on the upper left. Move the tom holder inward as shown in the close-up illustration (n). [. . . ]