User manual YAMAHA DTXPRESS IV STANDARD SET ASSEMBLY MANUAL

[. . . ] They may be pinched, resulting in injury. Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or high humidity (bathroom, outside on a rainy day, etc. ). Doing so may result in deformation, discoloration, damage or deterioration. When cleaning the product, do not use benzine, thinner or alcohol as it may result in discoloration or deformation. [. . . ] Loosen the two knobs ((g) on the middle right) aligned at the base of pipe . Move pipe in a counterclockwise direction until it is about 90 degrees from the pipe with the YAMAHA logo. Tighten the two knobs loosened and fix the position of pipe . Loosen the knobs (h) and (j) (shown with on the opposite side of pipe ) of the cymbal and on the right and left and pull up the cymbal holders vertically to the holders height illustrated. Tighten the knobs loosened and fix the positions of the cymbal holders. Loosen the two knobs ((k) on the middle left) aligned at the base of pipe and the knob all the way ((m) on the lower left) on the slim pipe supporting pipe . Move pipe in a counterclockwise direction until it is about 90 degrees from around the vertical pipe the pipe with the YAMAHA logo. Tighten the three knobs loosened and fix the position of and the slim pipe supporting it. pipe Stopper (2) PRECAUTIONS Before using, please read this assembly manual, and use this product in a safe and proper manner. Particularly in the case of children and young users, parents or an instructor should teach the children the proper manner in which to use the device. *1 Use cable bands to bind cables to pipes in " *2 Not this manual. (Spare bands are included. ) 8 9 HH65 (Hi-Hat Controller) (1) KP65 (Kick Pad) (1) Drum Key (1) WARNING If this symbol is ignored and the equipment is used improperly, fatal injury to persons or serious damage could occur. Assembling the Rack System 1 Take out the rack system from the package and remove all the cushioning. Remove the bubble wrap on the pipes while assembling the rack system. Do not let small children assemble or set up this product by themselves, or they may be injured. Always assemble this product with adult supervision. Be careful with the edges of the cymbal holders and the tom holders. The sharp holder ends may result in injury. Be careful with the edges of the spurs attached to the base. The sharp spur ends may result in injury. If this product is used with the rack system or a cymbal stand, make sure all bolts are tightened firmly. Also, when adjusting the height or angle, do not suddenly loosen the bolts. Loose bolts may result in the rack overturning or parts dropping, causing injury. [. . . ] Attach the included round-shaped felt with a large hole-diameter to the cymbal holder, then attach the wing nut removed in step 1 and tighten it. Turn the wing nut until you are certain that the cymbal pad is attached. The cymbal pad is designed to shake when you hit the surface, even when the wing nut is tightened securely. Figure 28: Using Cable Band 3 Figure 24: 9-channel Snake Cable Use the cable bands to bind the cables to the pipes at the six points marked with circles. Mounting the DTXP4 (Trigger module) Figure 18: Pads Assembly-4 Figure 19: Module stand * Leaving the cable slacked may interfere with your performance. T E S R 2 3 See Figure 11. Loosen the knobs of the tom holders and at the center of the rack system (shown with ). [. . . ]