User manual YAMAHA F60 JET DRIVE-2005

[. . . ] F50D T50D F60D T60D OWNER'S MANUAL U. S. A. Edition LIT-18626-06-11 6C1-28199-10 EMU25060 ZMU01690 Read this owner's manual carefully before operating your outboard motor. Important manual information EMU25100 To the owner Thank you for choosing a Yamaha outboard motor. This Owner's Manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] Ring Free Fuel Additive has repeatedly proven its ability to clean combustion deposits from inside the engine, notably the critical piston-ring-land area, and G Before starting the engine, make sure that the boat is tightly moored and that you can steer clear of any obstructions. Be sure there are no swimmers in the water near you. When the air vent screw is loosened, gasoline vapor will be released. Gasoline is highly flammable, and its vapors are flammable and explosive. Refrain from smoking, and keep away from open flames and sparks while loosening the air vent screw. This product emits exhaust gases which contain carbon monoxide, a colorless, odorless gas which could cause brain damage or death when inhaled. Symptoms include nausea, dizziness, and drowsiness. Keep cockpit and cabin areas well ventilated. If there is an air vent screw on the fuel tank cap, loosen it 2 or 3 turns. 1. ZMU02295 2. If there is a fuel joint on the motor, firmly 28 Operation connect the fuel line to the joint. Then firmly connect the other end of the fuel line to the joint on the fuel tank. ZMU02025 EMU27490 Starting engine ZMU03679 EMU27662 Electric start and remote control models 1. Place the remote control lever in neutral. ZMU02024 3. If a steering friction adjuster is provided on your outboard motor, securely attach the fuel line to the fuel line clamp. NOTE: The start-in-gear protection device prevents the engine from starting except when in neutral. Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg. Then install the lock plate on the other end of the lanyard into the engine stop switch. NOTE: During engine operation place the tank horizontally, otherwise fuel cannot be drawn from the fuel tank. Squeeze the primer pump with the outlet end up until you feel it become firm. EWM00120 WARNING G G Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. Do not attach the lanyard to clothing that could tear loose. Do not route the 29 Operation G lanyard where it could become entangled, preventing it from functioning. Avoid accidentally pulling the lanyard during normal operation. Loss of engine power means the loss of most steering control. Also, without engine power, the boat could slow rapidly. This could cause people and objects in the boat to be thrown forward. for more than 5 seconds. If the starter motor is turned continuously for more than 5 seconds, the battery will be quickly discharged, thus making it impossible to start the engine. If the engine will not start after 5 seconds of cranking, return the main switch to " " (on), wait 10 seconds, then crank the engine again. NOTE: G G When the engine is cold, it needs to be warmed up. [. . . ] Do not install the starter mechanism or top cowling after the engine is running. Do not touch the ignition coil, spark plug wire, spark plug cap, or other electrical components when starting or operating the motor. You could get an electrical shock. ther information, see page 29. Be sure the engine is in neutral and that the engine stop switch lanyard lock plate is attached to the engine stop switch. 4. Turn on the main switch. OFF ON START ZMU01906 5. EMU29581 Emergency starting engine 1. [. . . ]