User manual YAMAHA F80HP-2000

[. . . ] In this Owner's Manual particularly important information is distinguished in the following ways. The Safety Alert Symbol means ATTENTION!YOUR SAFETY IS INVOLVED! CAUTION: A CAUTION indicates special precautions that must be taken to avoid damage to the outboard motor. @ NOTE: A NOTE provides key information to make procedures easier or clearer. @ @ * Yamaha continually seeks advancements in product design and quality. Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your machine and this manual. [. . . ] Any part of inferior quality may malfunction, and the resulting loss of control could endanger the operator and passengers. Yamaha genuine parts and accessories are available from a Yamaha dealer. 4-10 E EMU00363¯ MAINTENANCE CHART Frequency of maintenance operations may be adjusted according to the operating conditions, but the following table gives general guidelines. The mark (G) indicates the check-ups which you may carry out yourself. The mark () indicates work to be carried out by your Yamaha dealer. Interval Item Spark plug Cleaning/Adjustment/ Replacement Greasing points Greasing Gear oil Change Fuel system Inspection Fuel filter Inspection/Replacement Fuel tank Cleaning Idling speed Adjustment Anode Inspection/Replacement Outboard motor exterior Inspection Cooling water passages (*2) Cleaning Propeller Inspection Timing belt Inspection/Replacement Battery(*1) Carburetor setting Bolts/Nuts Engine oil Valve clearance Thermostat Inspection/Charge Inspection/Adjustment Retightening Change Inspection/Adjustment Inspection Initial Every 10 hours 50 hours 100 hours 200 hours (1 month) (3 months) (6 months) (1 year) G G G G G G G G G G G G G G G(every 1 month) G G G G G G Refer page 4-13 4-12 4-25 4-15 4-16 4-27 4-17 4-28 4-34 4-33 4-23 4-20 4-29 G -- 4-32 4-18 -- -- *1. When operating in salt water, turbid or muddy water, the engine should be flushed with clean water after each use. NOTE: If leaded gasoline is usually used, engine valves and related parts should be inspected after every 300 hours of operation in addition to the items on the maintenance chart above. @" @ 4-11 E EMU00366 GREASING Yamaha marine grease (Water resistant grease) 4-12 E EMU01202 CLEANING AND ADJUSTING SPARK PLUG WARNING @ When removing or installing a spark plug, be careful not to damage the insulator. A damaged insulator could allow external sparks, which could lead to explosion or fire. @ The spark plug is an important engine component and is easy to inspect. The condition of the spark plug can indicate something about the condition of the engine. For example, if the center electrode porcelain is very white, this could indicate an intake air leak or carburetion problem in that cylinder. Do not attempt to diagnose any problems yourself. Instead, take the outboard motor to a Yamaha dealer. You should periodically remove and inspect the spark plug because heat and deposits will cause the spark plug to slowly break down and erode. Improper assembly or replacement can result in a fuel leak, which could result in a fire or explosion hazard. @ EMU00374¯ Check the fuel filter periodically. The fuel filter is a one-piece, disposable type. If foreign matter is found in the filter, replace it. For replacement of the fuel filter, consult a Yamaha dealer. 4-16 E EMU00991 ADJUSTING IDLING SPEED WARNING @ G G Do not touch or remove electrical parts when starting or during operation. Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running. @ CAUTION: @ This procedure must be performed while the outboard motor is in the water. A flushing attachment or test tank can be used. @ A diagnostic tachometer should be used for this procedure. 1) Start the engine and allow it to warm up fully in Neutral until it is running smoothly. If the outboard is mounted on a boat, be sure the boat is tightly moored. 2) Adjust the throttle stop-screw 1 to set the idling speed to specification (see "SPECIFICATIONS" on page 4-1) by turning the stop-screw clockwise to increase the idling speed, and turning it counterclockwise to decrease the idling speed. NOTE: Correct idling-speed adjustment is only possible if the engine is fully warmed-up. If not warmed up fully, the speed setting will tend to be too high. [. . . ] Normal deterioration. SPECIFIC PARTS EXCLUDED FROM WARRANTY. Parts replaced due to normal wear or routine maintenance such as oil, spark plugs, shear pins, propellers, hubs, fuel and oil filters, brushes for the starter motor and power tilt motor, water pump impellers, and anodes, are not covered by warranty. Charges for removal of the motor from a boat and transporting the motor to and from an authorized Yamaha Outboard Motor Dealer are excluded from warranty coverage. Specific parts excluded from the second and third year of warranty (if applicable) are: G Top and Bottom Cowling G Electric Components (other than ignition system) G Rubber Components (such as hoses, tubes, rubber seals, fittings, and clamps) TRANSFER OF WARRANTY. [. . . ]