User manual YAMAHA GP800-2000

[. . . ] WaveRunner GP GP800Y OWNER'S/OPERATOR'S MANUAL READ THIS MANUAL CAREFULLY BEFORE OPERATION! U. S. A. Edition YAMAHA MOTOR CORPORATION, U. S. A. LIT-18626-03-86 E EJU00270 TO THE OWNER Thank you for choosing a Yamaha Water Vehicle. This Owner's Manual contains information you will need for proper operation, maintenance, and care. A thorough understanding of these simple instructions will help you to obtain maximum enjoyment from your new Yamaha. If you have any questions about the operation or maintenance of your water vehicle, please consult a Yamaha dealer. [. . . ] You increase your chance of hitting an underwater obstacle. Operate at higher speeds only in deep water free of under water obstacles. 2) 3) 4) Run the engine at the lowest possible speed for the first five minutes. Gradually open the throttle to 3/4 or less. Continue operation at 3/4 - throttle or less until the first tankful of fuel has been used up. Fill the tank with a straight gasoline, and proceed with normal operation. 5) cC Failure to follow the break-in (running-in) procedure properly can result in severe damage to the engine. 3-10 E EJU00461a STARTING THE ENGINE w This product emits exhaust gases which contain carbon monoxide, a colorless, odorless gas which may cause brain damage or death when inhaled. Symptoms include nausea, dizziness, and drowsiness. 1) Always make sure the vehicle is launched and used in waters that are free from weeds and debris, and in depths of at least 60 cm (2 feet). w 60 cm (2 ft) GP7-077 Never ride in water that is less than 60 cm (2 feet) deep. You increase your chance of hitting an underwater obstacle. Operate at higher speeds only in deep water free of under water obstacles. cC Never ride in water that is less than 60cm (2 feet) deep. Pebbles or sand could be sucked into the jet intake, causing impeller damage or engine overheating. GP7-015 2) Turn the fuel cock to the "ON" position. NOTE: Before the first start-up, remove the fuel tank filler cap to release any built-up pressure in the tank because of fuel expansion. GP7-078 3-11 E e 3) q Attach the lock plate to the engine stop lanyard switch. Also, attach the lanyard to your left wrist. 1 Engine stop lanyard switch 2 Lanyard 3 Lock plate w GP7-079 w Check that the lanyard is not frayed or broken, wrapped around the handlebars, or tangled in controls. If the operator falls off, the vehicle could continue to run and cause an accident. The operator would also be unable to rebound the vehicle, which increases the chance of being hit by another boat and the risk of exposure. NOTE: It is not possible to start the engine with the lock plate removed from the engine stop lanyard switch. 4) Pull the choke knob all the way out to start a cold engine. GP7-080 NOTE: The choke should not be used when the engine is warm. 5) If the "LOCK" mode was chosen previously, chose the "START" mode before starting the engine. To set the mode, refer to "PADLOC" in "MULTIFUNCTION METER". GP7-081 3-12 E NOTE: 8 If initial setting of the PADLOC has not been done, the "START" mode is automatically selected. 8 If you have previously chosen "LOCK" mode, the engine will not start unless the right code is put in to select "START" mode. 6) While lightly squeezing the throttle lever, push the starter switch (green button). w On this vehicle, the engine is connected directly to the drive unit. Starting the engine immediately generates some thrust. [. . . ] has an up-to-date registration record in accordance with federal law. 6-5 YAMAHA EXTENDED SERVICE (Y. E. S. ) Keep your Yamaha protected even after your warranty expires with genuine Yamaha Extended Service (Y. E. S. ). is designed and administered by Yamaha Motor Corporation to provide maximum owner satisfaction. You get uninterrupted factory-backed coverage for extra peace of mind. You choose the plan that's right for you: 12 months, 24 months, or 36 months beyond your warranty period. [. . . ]