User manual YAMAHA HAF3-S18-W-

[. . . ] ARRAY FRAME EN PRECAUTIONS CAUTION PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep this manual in a safe place for future reference. HAF3-S18(W) Owner's Manual Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the device or other property. These precautions include, but are not limited to, the following: Thank you for choosing this Yamaha product. [. . . ] · Some fittings may deteriorate over extended periods of time due to wear and/or corrosion. For optimum safety, the installation should be checked thoroughly at regular intervals. Package Contents HAF3-S18(W) 3-1171 3-1174 3-0235 2-1432 3-0112 Angle indicator plates (2 pcs. ) Rear joiner plate (2 pcs. ) M10-40mm button head socket screws (14 pcs. ) M10 flat washers (16 pcs. ) M10 L-key wrench (1 pc. ) NOTE · Use only the eye bolts included with the speaker unit. · For information on load limits and the strength of the eyebolt, refer to the owner's manual of the speaker. Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure or improper installation. * Illustrations herein are for explanatory purposes only, and may not match actual appearance during operation. * Company names and product names herein are trademarks or registered trademarks of their respective companies. * Specifications and descriptions in this owner's manual are for information purposes only. reserves the right to change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer. Installation Instructions M10 Flat Washer [TYP] M10 EyeBolt [4X] Rear Joiner Plate (3-1174)[2X] M10 Screw [TYP] Dimensions 3-1171 Angle Indicator Plate . 402 28X 20. 75 1. Remove the existing speaker screws. Angle Indicator Plate (3-1171)[2X] 2. Determine the splay angle of the speaker and the holes to use on the front joiner plate. 3. Install a rear joiner plate on the rear inserts of the cluster with the provided screws and flat washers. Install an angle indicator plate on the front inserts using the corresponding holes for the appropriate splay angles with the screws and flat washers. [. . . ] For steep tilt angles, move the rear eye bolts to the rear bottom insert of the speaker cluster and use as a pull back point. Make sure to replace the eye bolts with the provided screws and washers. 90 6. 78 Tight Pack Configuration 37. 68 40. 47 90 Maximun Splay Configuration [. . . ]