User manual YAMAHA HS840/740

[. . . ] HI-HAT STAND HS840/HS740 OWNER'S MANUAL r Spring Tension Knob The Spring Tension Knob supplies tension control over a 11-step range, To increase tension, slide the Spring Tension Knob up (Fig. [. . . ] lithium grease) to all of the moving parts as needed. u Leg Position Adjustment Leg · Leg q Cymbal Support Plate To install the bottom hi-hat cymbal, remove the hi-hat clutch assembly and place the cymbal on the felt washer on the cymbal support plate. The angle of the bottom cymbal can be adjusted by turning the angle bolt on the underside of the support plate. To adjust the angle of the hi-hat cymbal, use the Knob Bolt located on the underside of the cymbal support. Leg Foot Board Loosen Bolts A and B shown in the illustration to the right to change the position of the legs (footboard). After the position has been determined, tighten both Bolts A and B firmly. Also, we recommend that the legs be positioned in the same manner as shown in the illustration on the left so as to leave some space available for setup and to provide sufficient stability for the stand. (This setup is for right-handed drummers. For left-handed drummers, please set up in an opposite manner. ) Knob Bolt Position Clamp Extender Base A w Hi-Hat Clutch To install the top hi-hat cymbal, loosen the wing bolt and remove the entire hihat clutch assembly from the upper pull rod. Next, remove the clutch nut and position the cymbal between the two clutch felts. [. . . ] Use a drum key to firmly tighten the position clamp into place. Cymbal Support Plate Knob Bolt Clutch Nut * This product photograph is HS840. * Specifications and design are subject to change without notice. Printed in Indonesia [. . . ]