User manual YAMAHA HTR-5440RDS

[. . . ] GB HTR-5440RDS Natural Sound AV Receiver Ampli-tuner audio-vidéo OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a well ventilated, cool, dry, clean place with at least 30 cm on the top, 20 cm on the right and left, and 10 cm at the back of this unit for ventilation space -- away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] Refer to the procedure in the section "To Recall a Preset Station" on page 29. Hold down (PRESET/ TUNING) EDIT for about 3 second. "E1" and the "MEMORY" indicator flash. PRESET /TUNING EDIT BASS EXT. MEMORY Flashes 3 Recall preset station "A5" by using the buttons on the front panel. "A5" and the "MEMORY" indicator flash. BASS EXT. MEMORY Flashes 4 Press (PRESET/TUNING) EDIT again. The display shows the exchange of stations has been completed. PRESET /TUNING EDIT MEMORY 30 RECEIVING RDS STATIONS Radio Data System (RDS) is a data transmission system by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal. RDS data contains various information such as PI (Program Identification), PS (Program Service name), PTY (Program Type), RT (Radio Text), CT (Clock Time), EON (Enhanced Other Networks), etc. The RDS function is carried out among the network stations. Changing the RDS Mode The four modes are available in this unit for displaying RDS data. When an RDS station is being received, PS, PTY, RT and/or CT that correspond to the RDS data services offered by the station light up on the display. Press RDS MODE/ FREQ repeatedly to change the display mode among the RDS data offered by the transmitting station in the order shown below. Illumination of the red indicator next to the RDS mode indicator shows that the corresponding RDS mode is now selected. INTRODUCTION PREPARATION Description of RDS Data This unit can receive PI, PS, PTY, RT, CT, and EON data when receiving RDS broadcasting stations. Notes · When an RDS station is being received, do not press RDS MODE/FREQ until one or more RDS mode indicators light up on the display. If you press the button before the indicators light up on the display, the mode cannot be changed. This is because the unit has not yet received all of the RDS data on the station. · RDS data not offered by the station cannot be selected. · The RDS data service cannot be utilized by this unit if the received signal is not strong enough. In particular, the RT mode requires a large amount of data to be received, so it is possible that the RT mode may not be displayed even if other RDS modes (PS, PTY, etc. ) are displayed. · RDS data cannot sometimes be received under poor reception conditions. If so, press TUNING MODE so that the "AUTO" indicator goes off from the display. Although the reception mode is changed to monaural by this operation, when you change the display to RDS mode, RDS data may be displayed. · If the signal strength is weakened by external interference during the reception of an RDS station, the RDS data service may be cut off suddenly and ". . . WAIT" will appear on the display. RDS MODE/FREQ I PS (Program Service name) mode: The name of the RDS station being received is displayed. I PTY (Program Type) mode: The program type on the RDS station being received is displayed. [. . . ] 37 MAIN SP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 REAR LR SP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Subwoofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 ADVANCED OPERATION E External decoder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]