User manual YAMAHA HTR-6025

[. . . ] U HTR-6025 AV Receiver OWNER'S MANUAL IMPORTANT SAFETY INSTRUCTIONS Important safety instructions 10 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 11 · Explanation of Graphical Symbols 12 The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert you to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 13 1 2 3 4 5 6 7 8 9 Read Instructions ­ All the safety and operating instructions should be read before the product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. [. . . ] y When performing this operation with the remote control, press C TUNER to select "TUNER" as the input source. Exchanging preset stations You can exchange the assignments of two preset stations with each other. The example below describes the procedure to exchange preset station "E1" with "A5". 1 1 Press 4 A/B/C/D/E (or G A/B/C/D/E l / h) repeatedly to select the desired preset station group (A to E). The preset station group letter appears in the front panel display and changes each time you press the button. Press 5 PRESET/TUNING l / h (or G PRESET/CH k / n) to select the desired preset station number (1 to 8). The preset station group and number appear in the front panel display along with the station band and frequency. Select preset station "E1" using 4 A/B/C/D/E and 5 PRESET/TUNING l / h. See "Selecting preset stations" on this page. Press and hold 2 PRESET/TUNING for more than 3 seconds. "E1" and the MEMORY indicator flash in the front panel display. Flashes 2 2 MEMORY E1 : FM 87. 5 MHz Flashes 3 E1 : FM 87. 5 MHz y You can select the desired preset station number (1 to 8) directly by pressing the numeric buttons on the remote control. Select preset station "A5" using 4 A/B/C/D/ E and 5 PRESET/TUNING l / h. "A5" and the MEMORY indicator flash in the front panel display. See "Selecting preset stations" on this page. Flashes MEMORY A5 : FM 90. 7 MHz Flashes 4 Press 2 PRESET/TUNING again. "EDIT E1­A5" appears in the front panel display and the assignments of the two preset stations are exchanged. 36 En RECORDING Recording Recording adjustments and other operations are performed from the recording components. Refer to the operating instructions for those components. Notes · When this unit is set to the standby mode, you cannot record between other components connected to this unit. · The settings of TONE CONTROL (see page 29) and VOLUME settings, speaker levels (see page 29) and the sound field programs (see page 31) do not affect recorded material. · The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded. · Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Therefore, if your source component is connected to provide only digital signals, you cannot record the source. · A given input source is not output on the same OUT (REC) channel. · Once you have connected a recording component to this unit, keep the component turned on while using this unit. If the component is turned off, this unit may distort the sound from other components. · Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright laws. y Do a test recording before you start an actual recording. BASIC OPERATION If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals. 1 2 Turn on all the connected components. [. . . ] 33 SILENT CINEMA indicator . . . . . . . . . . . . . . . . 19 SLEEP indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Sleep timer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Sound field programs . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]