User manual YAMAHA KX-W321

[. . . ] Please record the serial number of this unit in the space below. Model: Serial No. : The serial number is located on the rear of the unit. Retain this Owner's Manual in a safe place for future reference. 14 15 1 2 3 4 5 6 Read Instructions ­ All the safety and operating instructions should be read before the unit is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. [. . . ] Be sure to read the "TROUBLESHOOTING" section on common operating errors before concluding that your unit is faulty. Do not place another component on top of this unit, as damage or discoloration on the surface of the unit may result. To prevent damage by lightning, disconnect the power cord from the wall outlet during an electrical storm. When disconnecting the power cord from the wall outlet, grasp the plug; do not pull the cord. Do not plug the AC power plug to the wall outlet before you finish all connections. The voltage to be used must be the same as that specified on this unit. Using this unit with a higher voltage than that which is specified is dangerous and may result in a fire or other type of accident causing damage. YAMAHA will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. Keep this manual in a safe place for future reference. Never allow metallic items (e. screwdrivers, tools, etc, ) to come near the record/playback head assembly. Doing so may not only scratch or damage the head's mirror-smooth finish, but also change the magnetic characteristics of the heads, causing a deterioration in reproduction quality. Notes · The blank interval between selections must be at least 4 seconds long. · Searching function may not operate properly with tapes recorded at a low recording level or which have excessive noise. · When you play the beginning part or end part of the tape, the search function may not work correctly. / 1 2 3 4 5 6 REC/ PAUSE 7 REC/ MUTE 8 CD SYNC 9 0 REC/PAUSE +10 TAPE 3 VOLUME MD INPUT SLEEP MUTE 2 ­ + 1 2 Press STANDBY/ON to turn on the unit and CRX-M5. Set the CRX-M5 to play mode for the source you want record from and set the CRX-M5 to recording mode for the cassette deck. Press ) to open the tape tray and place a blank tape on the tray. 3 E-8 Getting Started Playing CDs OPERATIONS 4 5 Press ) to close the tape tray. Press DOLBY NR to set the DOLBY NR function to ON (DOLBY NR indicator lights up) or OFF (DOLBY NR indicator goes out). ON: For recording with DOLBY NR ON. To insert a blank space during recording Press REC MUTE during recording or Rec/Pause mode. A 4 seconds blank interval is automatically recorded on the tape and then the unit enters Rec/Pause mode. To resume recording, press REC/PAUSE. English 6 Press MODE to select the reverse mode. Each time you press MODE, the reverse mode changes and the corresponding MODE indicator lights up as follows: : One side of the tape is recorded. , : Both sides of the tape are recorded. 7 Press REC/PAUSE. The unit stands by for recording and the REC indicator flashes. [. . . ] Cannot record Sound is distorted or fades out. Head is dirty. Excessive noise. Tape encoded with DOLBY NR is played back with the unit's DOLBY NR OFF. Tape is worn. Tape travel stops in middle of playback or recording. Slack tape coming out of cassette shell. Endless tape is being used. The CD synchronized recording function does not works. [. . . ]