User manual YAMAHA KX-W482

[. . . ] s KX­ W582 ­ KX W482 s DECK A DECK B s DECK A DECK B Natural Sound Stereo Cassette Deck OWNER'S MANUAL Í 1 IMPORTANT Please record the serial number of your unit in the space below. Model: Serial No: The serial number is located on the rear of the unit. Retain this Owner's Manual in a safe place for future reference. Thank you for purchasing the YAMAHA stereo cassette deck. SAFETY INSTRUCTIONS 7 Wall or Ceiling Mounting -- The appliance should be CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN mounted to a wall or ceiling only as recommended by the manufacturer. 8 Ventilation -- The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug or similar surfaces that may block the ventilation openings: or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). [. . . ] ": When recording on one side of a tape is finished, the deck stops at the end of the tape. ": Both sides of a tape are recorded. After recording, the deck stops at the end of the tape. ÷ When the tape running direction is set to TM, only the reverse side is recorded. RELAY: Cassette tapes loaded in DECKs A and B are recorded sequentially. (See "RELAY RECORDING" on page 15. ) Setting the recording level (in step 8) Play the loudest passage of the source to be recorded and watch the meter readings. Adjust the REC LEVEL control so that the highest peak reaches +4 of the optimum recording level. Normally, it is best to adjust the BALANCE control such that the left and right meter readings are even. Display during recording KX-W582 Tape counter Use the tape counter to aid in locating a point on a tape (0000 to 9999). To set the counter reading to "0000", press the RESET button. Tape running direction indicator REC indicator REC indicator SYNCHRO DUB NORM HIGH HALL DISCO CHURCH ¤A< REC ¤B< REC DSS PRESET PROGRAM indicators JAZZ CLUB L dB R ­ 30 20 15 10 8 6 4 2 0 2 4 6 + Peak level meters Indicate the peaks of the signal levels during recording and playback over a ­30 dB to +6 dB range. There are separate meters for each left and right channel. These level meters have a peak hold function which holds the peak level for about 1. 5 seconds. Tape counter Use the tape counter to aid in locating a point on a tape (0000 to 9999). To set the counter reading to "0000", press the RESET button. KX-W482 REC indicator Tape running direction indicator REC indicator SYNCHRO DUB NORM HIGH ¤A< REC ¤B< REC L dB R ­ 30 20 15 10 8 6 4 2 0 2 4 6 + Peak level meters Indicate the peaks of the signal levels during recording and playback over a ­30 dB to +6 dB range. There are separate meters for each left and right channel. These level meters have a peak hold function which holds the peak level for about 1. 5 seconds. To stop recording: Press the STOP button. To stop recording temporarily: Press the REC/PAUSE button. To resume recording, press the PLAY button. 12 ! s / MUTE/SEARCH DECK A DECK B REC MUTE operation - Inserting a blank space during recording During recording: MUTE/SEARCH During Rec mute operation, the REC indicator blinks. A 4-second blank interval is automatically recorded on the tape and then the deck enters Rec pause mode. If a blank interval longer than 4 seconds is desired, keep pressing for as long as you want. When the MUTE/ SEARCH button is released, the deck enters Rec pause mode after making a 4-second blank interval. To resume recording, press the PLAY button. ÷ If a blank interval shorter than 4 seconds is desired, press the PLAY button at the desired point during Rec mute mode. Recording will be resumed from that point. REC RETURN operation - To return to the point at which the recording started During recording: When the # indicator is lit: ! When the @ indicator is lit: / ÷ If the PLAY button is pressed during recording, Rec return operation automatically rewinds the tape to the point where the PLAY button was pressed. [. . . ] 74 dB Frequency Response (­20 dB) Type I/Normal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 ~ 17, 000 Hz ±3 dB Type II/High (CrO2) . . . . . . . . . . . . . . . . . . . . . . 20 ~ 18, 000 Hz ±3 dB Type IV/Metal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 ~ 20, 000 Hz ±3 dB Harmonic Distortion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]